TMPM364F10FG Toshiba, TMPM364F10FG Datasheet - Page 195

• Manufacturer Part Number: TMPM364F10FG
• Manufacturer: Toshiba

Specifications of TMPM364F10FG

• Product Summaries: Summary
• Lead Free: Yes
• Rohs Compatible Product(s): Available
• Rom (kbytes): 1024K
• Rom Type: Flash
• Ram (kbytes): 64K
• Number Of Pins: 144
• Package: LQFP(20x20)
• Vcc: 3V
• Cpu Mhz: 64
• Ssp (ch) Spi: 1
• I2c/sio (ch): 5
• Uart/sio (ch): 12
• Usb: Host
• Can: 1
• Ethernet: -
• External Bus Interface: Y
• Cs/wait Controller (ch): 4
• Dma Controller: 2
• 10-bit Da Converter: -
• 10-bit Ad Converter: 16
• 12-bit Ad Converter: -
• 16-bit Timer / Counter: 16
• Motor / Igbt Control: -
• Real Time Clock: Y
• Watchdog Timer: Y
• Osc Freq Detect: -
• Clock Gear: Y
• Low-power Hold Function: Y
• Remote Control Interface: Y
• Hardware Cec Controller: Y
• Comparators: -
• Low-voltage Detector: -
• Etm Hardware Trace: 4-bit

8.2.8
Type
8.2.8.1
8.2.8.2
in units of bits. Besides the general-purpose input / output function, the port H performs the serial bus inter-
face function(I2C/SIO), External signal interrupt function and 16bit timer input function.
to the corresponding bit of the two registers. If you use the port H as other than a general-purpose port, set
"1" to the corresponding bit of the function register. Do not set "1" to the both function registers at the same
time.
input in the PHIE register. These settings enable the interrupt input even if the CGSTBYCR<DRVE> bit in
the clock / mode control block is set to stop driving of pins during STOP mode.
Port H data register
Port H output control register
Port H function register 1
Port H function register 2
Port H open drain control register
Port H pull-upcontrol register
Port H input control register
Port H (PH0 to PH7)
The port H is a general-purpose, 8-bit input / output port. For this port, inputs and outputs can be specified
Reset initializes all bits of the port H as general-purpose ports with input, output and pull-up disabled.
The Port H has two types of of function register. If you use the port H as a general-purpose port, set "0"
To use the external interrupt input for releasing STOP mode, select this function in the PHFR1 and enable
Note:In modes other than STOP mode, interrupt input is enabled regardless of the PHFR1 register setting
Port H Circut Type
Port H register
if input is enabled in PxIE. Make sure to disable unused interrupts when programming the device.
T13
7
T12
6
Register name
T12
5
Page 169
T12
4
PHDATA
PHPUP
PHFR1
PHFR2
PHCR
PHOD
PHIE
T13
3
T12
Base Address = 0x400C_0700
2
Address (Base+)
0x000C
0x002C
0x0000
0x0004
0x0008
0x0028
0x0038
T12
1
TMPM364F10FG
T12
0