CY8CTST200-48LTXIT Cypress Semiconductor Corp, CY8CTST200-48LTXIT Datasheet - Page 196

• Manufacturer Part Number: CY8CTST200-48LTXIT
• Description: IC MCU 32K FLASH 48-QFN
• Manufacturer: Cypress Semiconductor Corp
• Series: TrueTouch™r

Specifications of CY8CTST200-48LTXIT

• Applications: Touchscreen Controller
• Core Processor: M8C
• Program Memory Type: FLASH (32 kB)
• Controller Series: CY8CT
• Ram Size: 2K x 8
• Interface: I²C, SPI, UART/USART, USB
• Number Of I /o: 38
• Voltage - Supply: 1.8 V
• Operating Temperature: -40°C ~ 85°C
• Mounting Type: Surface Mount
• Package / Case: 48-QFN
• Processor Series: CY8CTxx2xx
• Core: M8C
• Data Bus Width: 8 bit
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant

USBIO_CR0
21.3.9
This register is a USBIO manual control register 0.
In the table above, note that reserved bits are grayed table cells and are not described in the bit description section below.
Reserved bits must always be written with a value of ‘0’. For additional information, refer to the
page 171
Bit
7
6
5
0
196
Individual Register Names and Addresses:
USBIO_CR0 : 0,34h
Access : POR
Bit Name
0,34h
TEN
TSE0
TD
RD
Name
in the Full-Speed USB chapter.
USBIO_CR0
USB I/O Control Register 0
RW : 0
TEN
7
RW : 0
TSE0
6
Transmit Enable. This bit is used to manually transmit on D+, D- pins. Normally, this bit must be
cleared to allow the internal SIE to drive the pins. The most common reason for manually transmitting
is to force a resume state on the bus.
0
1
Both D+ and D- are low. There is no effect if TEN=0.
This bit transmits a USB J or K state on the USB bus. There is no effect if TEN=0 or TSE0=1.
0
1
This read only bit gives the state of the USB differential receiver.
0
1
Description
PSoC CY8CTMG20x and CY8CTST200 TRM, Document No. 001-53603 Rev. *C
Manual transmission off.
Manual transmission enabled.
Force USB K state.
Force USB J state.
D+ < D- or D+ = D- = 0.
D+ > D-.
RW : 0
TD
5
4
3
2
Register Definitions on
1
0,34h
R : 0
RD
0
[+] Feedback