H8S-2350 RENESAS [Renesas Technology Corp], H8S-2350 Datasheet - Page 244

• Manufacturer Part Number: H8S-2350
• Description: 16-Bit Single-Chip Microcomputer
• Manufacturer: RENESAS [Renesas Technology Corp]

Section 7 DMA Controller (DMAC)
Bit 13—Single Address Enable 1 (SAE1): Specifies whether channel 1B is to be used for
transfer in dual address mode or single address mode.
This bit is invalid in full address mode.
Bit 12—Single Address Enable 0 (SAE0): Specifies whether channel 0B is to be used for
transfer in dual address mode or single address mode.
This bit is invalid in full address mode.
Bits 11 to 8—Data Transfer Acknowledge (DTA): These bits enable or disable clearing, when
DMA transfer is performed, of the internal interrupt source selected by the data transfer factor
setting.
When DTE = 1 and DTA = 1, the internal interrupt source selected by the data transfer factor
setting is cleared automatically by DMA transfer. When DTE = 1 and DTA = 1, the internal
interrupt source selected by the data transfer factor setting does not issue an interrupt request to the
CPU or DTC.
When DTE = 1 and DTA = 0, the internal interrupt source selected by the data transfer factor
setting is not cleared when a transfer is performed, and can issue an interrupt request to the CPU
or DTC in parallel. In this case, the interrupt source should be cleared by the CPU or DTC
transfer.
When DTE = 0, the internal interrupt source selected by the data transfer factor setting issues an
interrupt request to the CPU or DTC regardless of the DTA bit setting.
Rev. 3.00 Sep 15, 2006 page 210 of 988
REJ09B0330-0300
Bit 13
SAE1
0
1
Bit 12
SAE0
0
1
Description
Transfer in dual address mode
Transfer in single address mode
Description
Transfer in dual address mode
Transfer in single address mode
(Initial value)
(Initial value)