sed1374 ETC-unknow, sed1374 Datasheet - Page 135

• Manufacturer Part Number: sed1374
• Description: Sed1374 Embedded Memory Color Lcd Controller
• Manufacturer: ETC-unknow

Epson Research and Development
Vancouver Design Center
7.4 Registers
Programming Notes and Examples
Issue Date: 99/04/27
REG[0Ch] Screen 1 Start Word Address LSB
bit 7
REG[0Dh] Screen 1 Start Word Address MSB
reserved
REG[1Ch] Line Byte Count Register
bit 7
REG[1Bh] SwivelView Mode Register
SwivelView
Mode Enable
bit 6
bit 14
bit 6
SwivelView
Mode Select
This section describes the registers used to set SwivelView mode operation.
The start address registers must be set for SwivelView mode. In SwivelView mode the
offset contained in the start address points to a byte.
The line byte count register informs the SED1374 of the stride, in bytes, between two
consecutive lines of display in SwivelView mode. The Line Byte Count register only
affects SwivelView mode operation. The contents of this register are ignored when the
SED1374 is in landscape display mode.
The SwivelView mode register contains several items for SwivelView mode support.
The first is the SwivelView Mode Enable bit. When this bit is “0” the SED1374 is in
landscape mode and the remainder of the settings in this register as well as the Line Byte
Count in REG[1Ch] are ignored. When this bit is a “1” SwivelView mode is enabled.
There are two SwivelView mode display schemes available. The SwivelView mode select
bit selects between the “Default Mode” and the "Alternate Mode”. The default mode offers
the lowest power consumption with some display mode limitations. The alternate mode
uses more power but offers greater display flexibility.
bit 5
bit 13
bit 5
n/a
bit 4
bit 12
bit 4
n/a
bit 3
bit 11
bit 3
n/a
bit 10
bit 2
bit 2
reserved
bit 1
bit 9
bit 1
SwivelView
Mode Pixel
Clock Select
Bit 1
bit 0
bit 8
bit 0
SwivelView
Mode Pixel
Clock Select
Bit 0
X26A-G-002-02
SED1374
Page 39