cs89712 Cirrus Logic, Inc., cs89712 Datasheet - Page 86

• Manufacturer Part Number: cs89712
• Description: High-performance, Low-power System-on-chip With 10base-t Ethernet Controller
• Manufacturer: Cirrus Logic, Inc.

3.5.4
The system status flags register is a 32-bit read only register, which indicates various system information. The bits
in the system status flags register SYSFLG1 are defined in
86
0
1
2
3
4:7
8
9
10
11
12
13
14
15
Bit
CLDFLG
SYSFLG1 — The System Status Flags Register (address 0x8000.0140)
CTXFF
VERID
31:30
DID
7:4
25
15
MCDR: Media changed direct read. This bit reflects the INVERTED non-latched status of the
media changed input.
DCDET: This bit will be set if a non-battery operated power supply is powering the system (it is
the inverted state of the nEXTPWR input pin).
WUDR: Wake up direct read. This bit reflects the non-latched state of the wakeup signal.
WUON: This bit will be set if the system has been brought out of the Standby State by a rising
edge on the wakeup signal. It is cleared by a system reset or by writing to the HALT or STDBY
locations.
DID: Display ID nibble. This 4-bit nibble reflects the latched state of the four LCD data lines. The
state of the four LCD data lines is latched by the LCDEN bit, and so it will always reflect the last
state of these lines before the LCD controller was enabled.
CTS: This bit reflects the current status of the clear to send (CTS) modem control input to
UART1.
DSR: This bit reflects the current status of the data set ready (DSR) modem control input to
UART1.
DCD: This bit reflects the current status of the data carrier detect (DCD) modem control input to
UART1.
UBUSY1: UART1 transmitter busy. This bit is set while UART1 is busy transmitting data, it is
guaranteed to remain set until the complete byte has been sent, including all stop bits.
NBFLG: New battery flag. This bit will be set if a low to high transition has occurred on the
nBATCHG input, it is cleared by writing to the STFCLR location.
RSTFLG: Reset flag. This bit will be set if the RESET button has been pressed, forcing the
nURESET input low. It is cleared by writing to the STFCLR location.
PFFLG: Power Fail Flag. This bit will be set if the system has been reset by the nPWRFL input
pin, it is cleared by writing to the STFCLR location.
CLDFLG: Cold start flag. This bit will be set if the CS89712 has been reset with a power on reset,
it is cleared by writing to the STFCLR location.
CRXFE
PFFLG
WUON
29
ID
24
14
3
Table 40. SYSFLG
BOOTBIT1
RSTFLG
UTXFF1
WUDR
28
23
13
Description
Table
2
40.
BOOTBIT0
URXFE1
DCDET
NBFLG
27
22
12
1
SSIBUSY
CS89712
UBUSY1
RTCDIV
MCDR
21:16
26
11
0
DS502PP2