SAM9G45 Atmel Corporation, SAM9G45 Datasheet - Page 681

• Manufacturer Part Number: SAM9G45
• Manufacturer: Atmel Corporation

Specifications of SAM9G45

• Flash (kbytes): 0 Kbytes
• Pin Count: 324
• Max. Operating Frequency: 400 MHz
• Cpu: ARM926
• Hardware Qtouch Acquisition: No
• Max I/o Pins: 160
• Ext Interrupts: 160
• Usb Transceiver: 3
• Usb Speed: Hi-Speed
• Usb Interface: Host, Device
• Spi: 2
• Twi (i2c): 2
• Uart: 5
• Lin: 4
• Ssc: 2
• Ethernet: 1
• Sd / Emmc: 2
• Graphic Lcd: Yes
• Video Decoder: No
• Camera Interface: Yes
• Adc Channels: 8
• Adc Resolution (bits): 10
• Adc Speed (ksps): 440
• Resistive Touch Screen: Yes
• Temp. Sensor: No
• Crypto Engine: No
• Sram (kbytes): 64
• Self Program Memory: NO
• External Bus Interface: 2
• Dram Memory: DDR2/LPDDR, SDRAM/LPSDR
• Nand Interface: Yes
• Picopower: No
• Temp. Range (deg C): -40 to 85
• I/o Supply Class: 1.8/3.3
• Operating Voltage (vcc): 0.9 to 1.1
• Fpu: No
• Mpu / Mmu: No/Yes
• Timers: 6
• Output Compare Channels: 6
• Input Capture Channels: 6
• Pwm Channels: 4
• 32khz Rtc: Yes
• Calibrated Rc Oscillator: No

35. Ethernet MAC 10/100 (EMAC)
35.1
35.2
6438G–ATARM–19-Apr-11
Description
Embedded Characteristics
The EMAC module implements a 10/100 Ethernet MAC compatible with the IEEE 802.3 stan-
dard using an address checker, statistics and control registers, receive and transmit blocks, and
a DMA interface.
The address checker recognizes four specific 48-bit addresses and contains a 64-bit hash regis-
ter for matching multicast and unicast addresses. It can recognize the broadcast address of all
ones, copy all frames, and act on an external address match signal.
The statistics register block contains registers for counting various types of event associated
with transmit and receive operations. These registers, along with the status words stored in the
receive buffer list, enable software to generate network management statistics compatible with
IEEE 802.3.
• Compatibility with IEEE Standard 802.3
• 10 and 100 MBits per second data throughput capability
• Full- and half-duplex operations
• MII or RMII interface to the physical layer
• Register Interface to address, data, status and control registers
• DMA Interface, operating as a master on the Memory Controller
• Interrupt generation to signal receive and transmit completion
• 128-byte transmit and 128-byte receive FIFOs
• Automatic pad and CRC generation on transmitted frames
• Address checking logic to recognize four 48-bit addresses
• Supports promiscuous mode where all valid frames are copied to memory
• Supports physical layer management through MDIO interface
• Supports Wake-on-LAN. The receiver supports Wake-on-LAN by detecting the following
events on incoming receive frames:
– Magic packet
– ARP request to the device IP address
– Specific address 1 filter match
– Multicast hash filter match
SAM9G45
681