CV500BI111 Omron, CV500BI111 Datasheet - Page 198

• Manufacturer Part Number: CV500BI111
• Description: Programmable Logic Controller
• Manufacturer: Omron

Specifications of CV500BI111

• Peak Reflow Compatible (260 C): No
• Leaded Process Compatible: No
• Lead Free Status / RoHS Status: Contains lead / RoHS non-compliant

Introduction
@RECV(98)
S
D
C
C + 1 1
C + 2
C + 3
S: Destination node beginning send word
D: Source node beginning receive word
C: Source node first control data word
C
15 14
1514131211
0: Source network address not specified (local network)
1: Source network address specified.
15
Destination (transmission source) unit address
00 (Hex):
01 to 0F (Hex): Computer (user program)
10 to 1F (Hex): Unit nos. 0 to 15
FE (Hex):
15
Destination network address
00 (Hex):
01 to 7F (Hex): 1 to 127
This setting is enabled only when Destination network address specified" is set in word C.
When specifying the destination network address, set all the nodes in the routing tables. For
details on the routing tables, refer to
Always " 1" for Controller Link Networks
Note
0: Operating level 1
1: Operating level 0
0: Response required
1: Response not required
"m" number of send words
0000 to 03DE (Hex): 0 to 990 words
Number of retries
0 to F (Hex): 0 to 15 retries
Direct/Indirect
0: Direct; 1: Indirect
8 7
8 7
1. When communicating in the same network with a CVM1 or CV-series PLC
2. With the message service, there is no guarantee that a message to a des-
0
PLC's CPU Unit
Unit connected to network
Local network
(02 to 0F (Hex) are used when
using Controller Link Support
Boards for PCI Bus only.)
manufactured prior to April 1996, the local network address cannot be set
to “00.” Set a number other than “00” as the local network address in the
routing tables, and then specify that number.
tination node will reach its destination. It is always possible that the mes-
sage may be lost in transit due to noise or some other condition. When
using the message service, it is advisable to prevent this situation from oc-
curring by performing resend processing at the node where instructions
are issued. With the SEND, RECV, and CMND instructions, resend pro-
0
0
0
0
0
Section 7 Network Interconnections.
Response monitor time
00 (Hex):
01 to FE (Hex): 0.1 to 25.4 s (unit: 0.1 s)
FF (Hex):
D
m
15
Source node
Destination (transmission source) node address (M)
01 to 20 (Hex): 1 to 32 (or 01 to 3E (Hex): 1 to 62)
The range of node addresses will vary for networks
other than Controller Link Networks.
2 s (for 2 Mbps)
4 s (for 1 Mbps)
8 s (for 500 Kbps)
No response monitoring
0
Destination node M
"m" num-
ber of
send
words
S
15
Section 6-1
0
173