CV500BI111 Omron, CV500BI111 Datasheet - Page 122

• Manufacturer Part Number: CV500BI111
• Description: Programmable Logic Controller
• Manufacturer: Omron

Specifications of CV500BI111

• Peak Reflow Compatible (260 C): No
• Leaded Process Compatible: No
• Lead Free Status / RoHS Status: Contains lead / RoHS non-compliant

C200HX/HG/HE Controller Link Units
4-3-3
Baud Rate (Pins 1 and 2)
Setting the Operating
Level (Pin 4)
Baud Rates and Operating Levels
Note
Note
Note Set the same baud rate for all the nodes on the Network. Normal communica-
Set the node address using a small flat-blade screwdriver, being careful not to
damage the rotary switches.
1. Always turn OFF the PLC’s power before setting the node address.
2. Do not set the same node address twice within the same Network. An error
3. The send sequence for the data link areas is determined according to the
4. Assign node addresses consecutively beginning from 01 whenever possi-
Set the following pins for the baud rate and operating level settings (DIP
switch).
1. Always turn OFF the PLC’s power before setting the baud rate or operating
2. Keep pin 3 set to OFF. If it is turned ON, internal data may be erased.
Set the same baud rate for all the nodes on the Network using DIP switch pins
1 and 2 on the front of the Unit. The baud rate is set as shown below.
The maximum transmission distance will also change according to the setting.
tion cannot be performed unless the same baud rate is set for all the nodes.
With C200HX/HG/HE PLCs, Networks can be constructed by mounting up to
two Communications Units, such as Controller Link Units, SYSMAC LINK
Units and SYSMAC NET Link Units for the same PLC Each of these Units
must run on a different operating level.
Set the Controller Link Unit to operating level 1 or 0 using DIP switch pin 4 on
the front of the Unit.
Setting method
Setting range
Node
OFF
ON
OFF
ON
will occur if the same address is set for two different nodes. The ERC indi-
cator on the front of the Unit will light and either communications will stop,
or the INS indicator will not light and you will be unable to participate in the
Network.
sequence of node addresses for automatically set data links.
ble to minimize Network construction time.
level.
Note The factory default setting is shown in bold.
Pin 1
Item
Note: The factory default settings are shown above.
ON
SW1
Pins
OFF
OFF
ON
ON
Pin 2
2-digit decimal
01 to 32 (default is 01)
All nodes in the Network
Pin 4:
Pin 3:
Pins 1, 2: Baud rate
2 Mbps
1 Mbps
500 Kbps
Do not set.
Baud rate
Operating level
Not used (must be OFF)
Specifications
500 m
800 m
1 km
Maximum transmission
distance
Section 4-3
97