LFDAS12XSDT Freescale Semiconductor, LFDAS12XSDT Datasheet - Page 573

• Manufacturer Part Number: LFDAS12XSDT
• Description: HARDWARE MC9S12XS 52-PIN
• Manufacturer: Freescale Semiconductor

Specifications of LFDAS12XSDT

• Module/board Type: *
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• For Use With/related Products: -

19.3.2.8
The FERSTAT register reflects the error status of internal Flash operations.
All flags in the FERSTAT register are readable and only writable to clear the flag.
Freescale Semiconductor
MGSTAT[1:0]
MGBUSY
ACCERR
Offset Module Base + 0x0007
Reset
FPVIOL
RSVD
Field
CCIF
1–0
7
5
4
3
2
W
R
Flash Error Status Register (FERSTAT)
7
0
0
Command Complete Interrupt Flag — The CCIF flag indicates that a Flash command has completed. The
CCIF flag is cleared by writing a 1 to CCIF to launch a command and CCIF will stay low until command
completion or command violation.
0 Flash command in progress
1 Flash command has completed
Flash Access Error Flag — The ACCERR bit indicates an illegal access has occurred to the Flash memory
caused by either a violation of the command write sequence (see
command. While ACCERR is set, the CCIF flag cannot be cleared to launch a command. The ACCERR bit is
cleared by writing a 1 to ACCERR. Writing a 0 to the ACCERR bit has no effect on ACCERR.
0 No access error detected
1 Access error detected
Flash Protection Violation Flag —The FPVIOL bit indicates an attempt was made to program or erase an
address in a protected area of P-Flash or D-Flash memory during a command write sequence. The FPVIOL
bit is cleared by writing a 1 to FPVIOL. Writing a 0 to the FPVIOL bit has no effect on FPVIOL. While FPVIOL
is set, it is not possible to launch a command or start a command write sequence.
0 No protection violation detected
1 Protection violation detected
Memory Controller Busy Flag — The MGBUSY flag reflects the active state of the Memory Controller
0 Memory Controller is idle
1 Memory Controller is busy executing a Flash command (CCIF = 0)
Reserved Bit — This bit is reserved and always reads 0
Memory Controller Command Completion Status Flag — One or more MGSTAT flag bits are set if an error
is detected during execution of a Flash command or during the Flash reset sequence. See
“Flash Command
= Unimplemented or Reserved
0
0
6
Figure 19-12. Flash Error Status Register (FERSTAT)
Description,” and
S12XS Family Reference Manual, Rev. 1.11
Table 19-15. FSTAT Field Descriptions
0
0
5
Section 19.6,
0
0
4
Description
“Initialization” for details.
.
0
0
3
Section
128 KByte Flash Module (S12XFTMR128K1V1)
0
0
2
19.4.1.2) or issuing an illegal Flash
DFDIF
0
1
Section 19.4.2,
SFDIF
0
0
.
573