S1D1 Epson Electronics America, Inc., S1D1 Datasheet - Page 245

• Manufacturer Part Number: S1D1
• Description: LCD Controller-driver With Built-in Character ROM
• Manufacturer: Epson Electronics America, Inc.

S1D15600/601/602 Series
• When the built-in power supply is not used immediately after the main power is turned on:
* This duration of 5 ms depends on the panel characteristics as well as capacity of the capacitor concerned. Check
Notes: *1: Refer to the “Reset Circuit” in the Function Description.
7–50
them on the actual system.
*2: Refer to the “ADC Select” in the Command Description (8).
*3: Refer to the “Output State Register Set” in the Command Description (18)
*4: Refer to the “Duty Select” in the Command Description (11).
*6: Refer to the “Supply Circuit” in the Function Description and the “Electronic Volume Register Set” in
*7: Refer to the “n-line Inversion Register Set” in the Command Description (13).
*8: Refer to the “Built-in Power Supply ON/OFF” in the Command Description (19).
*11,12: You can select either the sleep mode or standby mode for the power save mode. Refer to the “Power
Turn V
Implement the power save sequence (multiple commands) *11
the Command Description (21).
Save (Multiple Commands)” in the Command Description (22).
DD
Implement the power save cancel sequence *12
Function select through the commands (user setup)
Cancel the reset mode (RES terminal = HIGH)
and V
Turn on the initial setup mode (Default) *1
ADC select *2
Output state register set *3
Duty select *4
Electronic volume *6
n-line inversion register set *7
Wait until the power supply is stabilized.
SS
power on with RES terminal being set to LOW.
Initial setup is complete
EPSON
The power save mode
must be turned on within
5 ms from powering on.
Rev. 4.6