M306N4FGTFP#U0 Renesas Electronics America, M306N4FGTFP#U0 Datasheet - Page 289

• Manufacturer Part Number: M306N4FGTFP#U0
• Description: MCU 5V 256K T-TEMP PB-FREE 100-Q
• Manufacturer: Renesas Electronics America
• Series: M16C™ M16C/6Nr

Specifications of M306N4FGTFP#U0

• Core Processor: M16C/60
• Core Size: 16-Bit
• Speed: 20MHz
• Connectivity: CAN, I²C, IEBus, SIO, UART/USART
• Peripherals: DMA, WDT
• Number Of I /o: 85
• Program Memory Size: 256KB (256K x 8)
• Program Memory Type: FLASH
• Ram Size: 10K x 8
• Voltage - Supply (vcc/vdd): 4.2 V ~ 5.5 V
• Data Converters: A/D 26x10b; D/A 2x8b
• Oscillator Type: Internal
• Operating Temperature: -40°C ~ 85°C
• Package / Case: 100-QFP
• For Use With: R0K3306NKS001BE - KIT DEV RSK RSK-M16C/6NKR0K3306NKS000BE - KIT DEV RSK RSK-M16C/6NK
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Eeprom Size: -

M16C/6N Group (M16C/6N4)
Rev.2.40
REJ09B0009-0240
Figure 21.8 Program Command
21.3.5.4 Program Command (40h)
The program command writes 2-byte data to the flash memory.
By writing xx40h in the first bus cycle and data to the write address in the second bus cycle, an
auto-program operation (data program and verify) will start. The address value specified in the first bus
cycle must be the same even address as the write address specified in the second bus cycle.
The FMR00 bit in the FMR0 register indicates whether an auto-program operation has been completed.
The FMR00 bit is set to 0 (busy) during auto-programming and to 1 (ready) when an auto-program
operation is completed.
After the completion of an auto-program operation, the FMR06 bit in the FMR0 register indicates
whether or not the auto-program operation has been completed as expected. (Refer to 21.3.8 Full
Status Check.)
An address that is already written cannot be altered or rewritten.
Figure 21.8 shows a flow chart of the Program Command.
The lock bit protects each block from being programmed inadvertently. (Refer to 21.3.6 Data Protect
Function.)
In EW1 mode, do not execute this command on the block where the rewrite control program is allocated.
In EW0 mode, the MCU enters read status register mode as soon as an auto-program operation starts.
The status register can be read. The SR7 bit in the status register is set to 0 at the same time an
auto-program operation starts. It is set to 1 when auto-program operation is completed. The MCU remains in
read status register mode until the read array command is written. After completion of an auto-program
operation, the status register indicates whether or not the auto-program operation has been completed
as expected.
Apr 14, 2006
page 265 of 376
NOTE:
1.Write the command code and data to even addresses.
Write the command code xx40h
to an address to be the written
Write data to an address
to be written
Program operation is
completed
Full status check
FMR00=1?
Start
YES
NO
21. Flash Memory Version