M306N4FGTFP#U0 Renesas Electronics America, M306N4FGTFP#U0 Datasheet - Page 221

• Manufacturer Part Number: M306N4FGTFP#U0
• Description: MCU 5V 256K T-TEMP PB-FREE 100-Q
• Manufacturer: Renesas Electronics America
• Series: M16C™ M16C/6Nr

Specifications of M306N4FGTFP#U0

• Core Processor: M16C/60
• Core Size: 16-Bit
• Speed: 20MHz
• Connectivity: CAN, I²C, IEBus, SIO, UART/USART
• Peripherals: DMA, WDT
• Number Of I /o: 85
• Program Memory Size: 256KB (256K x 8)
• Program Memory Type: FLASH
• Ram Size: 10K x 8
• Voltage - Supply (vcc/vdd): 4.2 V ~ 5.5 V
• Data Converters: A/D 26x10b; D/A 2x8b
• Oscillator Type: Internal
• Operating Temperature: -40°C ~ 85°C
• Package / Case: 100-QFP
• For Use With: R0K3306NKS001BE - KIT DEV RSK RSK-M16C/6NKR0K3306NKS000BE - KIT DEV RSK RSK-M16C/6NK
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Eeprom Size: -

M16C/6N Group (M16C/6N4)
Rev.2.40
REJ09B0009-0240
16.1 Mode Description
Table 16.2 One-shot Mode Specifications
Function
A/D conversion
start condition
A/D conversion
stop condition
Interrupt request
generation timing
Analog input pin
Reading of result of
A/D converter
16.1.1 One-shot Mode
In one-shot mode, analog voltage applied to a selected pin is converted to a digital code once.
Table 16.2 lists the One-shot Mode Specifications. Figure 16.4 shows Registers ADCON0 and ADCON1 in
One-shot Mode.
Apr 14, 2006
Item
page 197 of 376
the ADCON2 register, and bits OPA1 to OPA0 in the ADCON1 register select
a pin Analog voltage applied to the pin is converted to a digital code once.
• When the TRG bit in the ADCON0 register is 0 (software trigger)
•
• Completion of A/D conversion (If a software trigger is selected, the ADST
• Set the ADST bit to 0
Completion of A/D conversion
Select one pin from AN0 to AN7, AN0_0 to AN0_7, AN2_0 to AN2_7,
ANEX0 to ANEX1
Read one of registers AD0 to AD7 that corresponds to the selected pin
Bits CH2 to CH0 in the ADCON0 register, bits ADGSEL1 to ADGSEL0 in
The ADST bit in the ADCON0 register is set to 1 (A/D conversion starts)
When the TRG bit is 1 (ADTRG trigger)
Input on the ADTRG pin changes state from high to low after the ADST
bit is set to 1 (A/D conversion starts)
bit is set to 0 (A/D conversion halted).)
_____________
_____________
Specification
16. A/D Converter