Z8F08200100KIT Zilog, Z8F08200100KIT Datasheet - Page 117

• Manufacturer Part Number: Z8F08200100KIT
• Description: DEV KIT FOR Z8 ENCORE 4K TO 8K
• Manufacturer: Zilog
• Series: Z8 Encore!®r
• Type: MCUr

Specifications of Z8F08200100KIT

• Contents: Evaluation Board, Cable, Power Supply, Software and Documentation
• Data Bus Width: 8 bit
• Interface Type: RS-485
• Silicon Manufacturer: Zilog
• Core Architecture: Z8 Encore
• Silicon Core Number: Z8F0822SJ020
• Silicon Family Name: XP F0822
• For Use With/related Products: Z8 Encore!™
• For Use With: 269-4661 - KIT ACC ETHERNET SMART CABLE
• Lead Free Status / RoHS Status: Contains lead / RoHS non-compliant
• Other names: 269-3183

Table 57. UART Control 1 Register (U0CTL1)
PS022517-0508
BITS
FIELD
RESET
R/W
ADDR
MPMD[1]
7
PSEL—Parity Select
0 = Even parity is transmitted and expected on all received data.
1 = Odd parity is transmitted and expected on all received data.
SBRK—Send Break
This bit pauses or breaks data transmission by forcing the Transmit data output to 0.
Sending a break interrupts any transmission in progress, so ensure that the transmitter has
finished sending data before setting this bit. The UART does not automatically generate a
STOP Bit when SBRK is deasserted. Software must time the duration of the Break and the
duration of any STOP Bit time desired following the Break.
0 = No break is sent.
1 = The output of the transmitter is zero.
STOP—STOP Bit Select
0 = The transmitter sends one stop bit.
1 = The transmitter sends two stop bits.
LBEN—Loop Back Enable
0 = Normal operation.
1 = All transmitted data is looped back to the receiver.
MPMD[1:0]—Multiprocessor Mode
If Multiprocessor (9-bit) mode is enabled,
00 = The UART generates an interrupt request on all received bytes (data and address).
01 = The UART generates an interrupt request only on received address bytes.
10 = The UART generates an interrupt request when a received address byte matches
11 = The UART generates an interrupt request on all received data bytes for which
MPEN—Multiprocessor (9-bit) Enable
This bit is used to enable Multiprocessor (9-bit) mode.
0 = Disable Multiprocessor (9-bit) mode.
1 = Enable Multiprocessor (9-bit) mode.
the value stored in the Address Compare Register and on all successive data
bytes until an address mismatch occurs.
the most recent address byte matched the value in the Address Compare Register.
MPEN
6
MPMD[0]
5
MPBT
4
F43H
R/W
0
DEPOL
3
Universal Asynchronous Receiver/Transmitter
BRGCTL
Z8 Encore! XP
2
Product Specification
RDAIRQ
1
®
F0822 Series
IREN
0
104