Z8F08200100KIT Zilog, Z8F08200100KIT Datasheet - Page 191

• Manufacturer Part Number: Z8F08200100KIT
• Description: DEV KIT FOR Z8 ENCORE 4K TO 8K
• Manufacturer: Zilog
• Series: Z8 Encore!®r
• Type: MCUr

Specifications of Z8F08200100KIT

• Contents: Evaluation Board, Cable, Power Supply, Software and Documentation
• Data Bus Width: 8 bit
• Interface Type: RS-485
• Silicon Manufacturer: Zilog
• Core Architecture: Z8 Encore
• Silicon Core Number: Z8F0822SJ020
• Silicon Family Name: XP F0822
• For Use With/related Products: Z8 Encore!™
• For Use With: 269-4661 - KIT ACC ETHERNET SMART CABLE
• Lead Free Status / RoHS Status: Contains lead / RoHS non-compliant
• Other names: 269-3183

Table 93. On-Chip Debugger Commands (Continued)
PS022517-0508
Debug Command
Execute Instruction
Reserved
In the following bulleted list of OCD Commands, data and commands sent from the host to
the OCD are identified by ’DBG ← Command/Data’. Data sent from the OCD back to the
host is identified by ’DBG → Data’
•
•
•
•
•
Read OCD Revision (00H)
version of the OCD. If OCD commands are added, removed, or changed, this revision
number changes.
Write OCD Counter Register (01H)
writes the data that follows to the OCDCNTR register. If the device is not in DEBUG
mode, the data is discarded.
Read OCD Status Register (02H)
the OCDSTAT register.
Read OCD Counter Register (03H)
count system clock cycles in between Breakpoints, generate a BRK when it counts
down to zero, or generate a BRK when its value matches the Program Counter. Since
this register is really a down counter, the returned value is inverted when this register
is read so the returned result appears to be an up counter. If the device is not in
DEBUG mode, this command returns FFFFH.
Write OCD Control Register (04H)
writes the data that follows to the OCDCTL register. When the Read Protect Option
Bit is enabled, the DBGMODE bit (OCDCTL[7]) can only be set to 1, it cannot be
cleared to 0 and the only method of putting the device back into normal operating
mode is to reset the device.
DBG ← 00H
DBG → OCDREV[15:8] (Major revision number)
DBG → OCDREV[7:0] (Minor revision number)
DBG ← 01H
DBG ← OCDCNTR[15:8]
DBG ← OCDCNTR[7:0]
DBG ← 02H
DBG → OCDSTAT[7:0]
DBG ← 03H
DBG → ~OCDCNTR[15:8]
DBG → ~OCDCNTR[7:0]
Command
Byte
13H - FFH
12H
Enabled when
NOT in DEBUG
mode?
—The Read OCD Revision command determines the
-
-
—The Read OCD Status Register command reads
—The Write OCD Control Register command
—The Write OCD Counter Register command
—The OCD Counter Register can be used to
Disabled by
Read Protect Option Bit
Z8 Encore! XP
Product Specification
Disabled
-
®
On-Chip Debugger
F0822 Series
178