Z8FMC04100 ZILOG [Zilog, Inc.], Z8FMC04100 Datasheet - Page 124

• Manufacturer Part Number: Z8FMC04100
• Description: Z8 Encore-R Motor Control Flash MCUs
• Manufacturer: ZILOG [Zilog, Inc.]

102
Z8 Encore!
Product Specification
General-Purpose Timer
Reading the Timer Count Values
Timer 0 High and Low Byte Registers
®
Motor Control Flash MCUs
The timer counts up to the 16-bit reload value stored in the Timer Reload High and Low
Byte registers. When reaching the reload value, the timer generates an interrupt, the count
value in the Timer High and Low Byte registers is reset to
as long as the Timer Input signal is active. Also, if the Timer Output alternate function is
enabled, the Timer Output pin changes state (from Low to High or from High to Low) at
timer reload.
The steps for configuring a timer for GATED mode and initiating the count are as follows:
1. Write to the Timer Control registers to:
2. Write to the Timer High and Low Byte registers to set the starting count value. This
3. Write to the Timer Reload High and Low Byte registers to set the reload value.
4. If appropriate, enable the timer interrupt and set the timer interrupt priority by writing
5. Configure the timer interrupt to be generated only at the input deassertion event, the
6. Configure the associated GPIO port pin for the Timer Input alternate function.
7. Write to the Timer Control 1 Register to enable the timer.
8. The timer counts when the Timer Input is equal to the
The current count value in the timers can be read while counting (enabled). This Read has
no effect on timer operation. When the timer is enabled and the Timer High Byte Register
is read, the contents of the Timer Low Byte Register are placed into a holding register. A
subsequent Read from the Timer Low Byte Register returns the value in the holding regis-
ter. This operation allows accurate Reads of the full 16-bit timer count value while
enabled. When the timer is not enabled, a Read from the Timer Low Byte Register returns
the actual value in the counter.
The Timer 0 High and Low Byte (T0H and T0L) registers, shown in Tables 58 and 59,
contain the current 16-bit timer count value. When the timer is enabled, a Read from T0H
a. Disable the timer.
b. Configure the timer for GATED mode.
c. Set the prescale value.
d. Select the active state of the Timer Input via the
setting only affects the first pass in GATED mode. After the first timer reset in
GATED mode, counting begins at the reset value of
to the relevant interrupt registers.
reload event, or both, by setting the
P R E L I M I N A R Y
TICONFIG
field of the Timer Control 0 Register.
TPOL
0001h
0001h
TPOL
bit.
.
bit.
, and counting continues
PS024604-1005