SAM3N0C Atmel Corporation, SAM3N0C Datasheet - Page 486

• Manufacturer Part Number: SAM3N0C
• Manufacturer: Atmel Corporation

28.10.5.3
Figure 28-27. Master Performs a General Call
486
486
GCACC
SVACC
TXD
SAM3N
SAM3N
General Call
S
GENERAL CALL
GENERAL CALL
0000000 + W
The general call is performed in order to change the address of the slave.
If a GENERAL CALL is detected, GACC is set.
After the detection of General Call, it is up to the programmer to decode the commands which
come afterwards.
In case of a WRITE command, the programmer has to decode the programming sequence and
program a new SADR if the programming sequence matches.
Figure 28-27 on page 486
Note:
This method allows the user to create an own programming sequence by choosing the program-
ming bytes and the number of them. The programming sequence has to be provided to the
master.
WRITE command = 00000100X
A
RESET command = 00000110X
Reset or write DADD
Reset after read
describes the General Call access.
A
DATA1
Programming sequence
New SADR
A
DATA2
A
New SADR
11011A–ATARM–04-Oct-10
11011A–ATARM–04-Oct-10
A
P