KIT_TC1797_SK Infineon Technologies, KIT_TC1797_SK Datasheet - Page 65

• Manufacturer Part Number: KIT_TC1797_SK
• Description: KIT STARTER AUDO FUTURE TC1797
• Manufacturer: Infineon Technologies
• Series: Audo Futurer
• Type: MCUr

Specifications of KIT_TC1797_SK

• Contents: Board, Adapters, Cables, CD, Power Supply
• Lead Free Status / Rohs Status: Lead free / RoHS Compliant
• For Use With/related Products: TC1797
• Other names: KITTC1797SKIN

Errata Sheet
Functional Deviations
Scope:
The erratum is limited to the case where the calculated rate correction value is
in the range of [-pClusterDriftDamping .. +pClusterDriftDamping].
Effects:
The displayed rate correction value RCV.RCV[11:0] is in the range of [-
pClusterDriftDamping .. +pClusterDriftDamping] instead of zero. The error of
the displayed value is limited to the range of [-pClusterDriftDamping ..
+pClusterDriftDamping]. For rate correction in the next double cycle always the
correct value of zero is used.
Workaround
A value of RCV.RCV[11:0] in the range of [-pClusterDriftDamping ..
+pClusterDriftDamping] has to be interpreted as zero.
FlexRay_AI.096 Noise following a dynamic frame that delays idle detec-
tion may fail to stop slot
Description:
If (in case of noise) the time between ’potential idle start on X’ and ’CHIRP on
X’
(see
Protocol
Spec.
v2.1,
Figure
5-21)
is
greater
than
gdDynamicSlotIdlePhase, the E-Ray will not remain for the remainder of the
current dynamic segment in the state ’wait for the end of dynamic slot rx’.
Instead, the E-Ray continues slot counting. This may enable the node to further
transmissions in the current dynamic segment.
Scope:
The erratum is limited to noise that is seen only locally and that is detected in
the time window between the end of a dynamic frame’s DTS and idle detection
(’CHIRP on X’).
Effects:
TC1797, EES-AC, ES-AC, AC
65/101
Rel. 1.3, 18.12.2009