28125 Parallax Inc, 28125 Datasheet - Page 202

• Manufacturer Part Number: 28125
• Description: TEXT ROBOTICS
• Manufacturer: Parallax Inc

Specifications of 28125

• Title: Robotics with the Boe-Bot
• Product: Microcontroller Accessories
• Lead Free Status / RoHS Status: Not applicable / Not applicable

SUMMARY
In this chapter, instead of navigating from a pre-programmed list, the Boe-Bot was
programmed to navigate based on sensory inputs. The sensory inputs used in this chapter
were whiskers, which served as normally open contact switches. When properly wired,
these switches can show one voltage (5 V) at the switch’s contact point when it’s open,
and a different voltage (0 V) when it’s closed. The BASIC Stamp I/O pin’s input
registers store “1” if they detect Vdd (5 V) and “0,” if they detect Vss (0 V).
The BASIC Stamp was programmed to test the whisker sensors and display the test
results using two different media, the Debug Terminal and LEDs. PBASIC programs
were developed to make the BASIC Stamp check the whiskers between each servo pulse.
Based on the state of the whiskers,
section called navigation subroutines similar to the ones developed in the previous
chapter to guide the Boe-Bot away from obstacles.
intelligence, an additional routine was developed that enabled the Boe-Bot to detect when
it got stuck in a corner. This routine involved storing old whisker states, comparing them
against the current whisker states, and counting the number of alternate object detections.
This chapter introduced sensor-based Boe-Bot navigation. The next three chapters will
focus on using different types of sensors to give the Boe-Bot vision. Both vision and
touch open up lots of opportunities for the Boe-Bot to navigate in increasingly complex
environments.
Questions
1. What kind of electrical connection is a whisker?
2. When a whisker is pressed, what voltage occurs at the I/O pin monitoring it?
3. If
4. What command is used to jump to different subroutines depending on the value
5. What is the purpose of having nested
What binary value will occur in the input register? If I/O pin P8 is used to
monitor the input pin, what value does
what value does it have when a whisker is not pressed?
IN5 = 1
of a variable? What command is used to decide which subroutine to jump to?
What are these decisions based on?
IN7 = 1
and
, what does that mean? What does it mean if
IN5 = 0
?
IF…THEN
statements in the program’s Main Routine
IF…THEN
IN8
have when a whisker is pressed, and
statements?
As an example of artificial
IN7 = 0
? How about