z8fmc16100 ZiLOG Semiconductor, z8fmc16100 Datasheet - Page 105

no-image

z8fmc16100

Manufacturer Part Number
z8fmc16100
Description
Z8 Encore Motor Control Flash Mcus
Manufacturer
ZiLOG Semiconductor
Datasheet

Available stocks

Company
Part Number
Manufacturer
Quantity
Price
Part Number:
z8fmc16100AKEG
Manufacturer:
LT
Quantity:
151
Part Number:
z8fmc16100AKEG
Manufacturer:
Zilog
Quantity:
10 000
Part Number:
z8fmc16100AKSG
Manufacturer:
Zilog
Quantity:
10 000
Part Number:
z8fmc16100QKEG
Manufacturer:
TOREX
Quantity:
2 000
PS024611-0408
TRIGGERED ONE-SHOT Mode Timeout Period (s) =
Note:
2. Write to the Timer High and Low Byte registers to set the starting count value.
3. Write to the Timer Reload High and Low Byte registers to set the reload value.
4. If appropriate, enable the timer interrupt and set the timer interrupt priority by writing
5. If using the Timer Output function, configure the associated GPIO port pin for the
6. Write to the Timer Control 1 register to enable the timer. Counting does not start until
The timer period is calculated by the following equation (Start Value = 1):
The one-shot delay from input trigger to output includes the above-defined timeout period,
plus an additional delay of 2–3 system clock cycles, due to the synchronization of the input
trigger.
CONTINUOUS Mode
In CONTINUOUS mode, the timer counts up to the 16-bit reload value stored in the Timer
Reload High and Low Byte registers. After reaching the reload value, the timer generates
an interrupt, the count value in the Timer High and Low Byte registers is reset to
and counting resumes. Also, if the Timer Output alternate function is enabled, the Timer
Output pin changes state (from Low to High or High to Low) after timer reload.
Follow the steps below to configure a timer for CONTINUOUS mode and initiate the
count:
1. Write to the Timer Control registers to:
(d) If using the Timer Output alternate function, set the initial output level (High or
(e) Set the INTERRUPT mode.
to the relevant interrupt registers.
Timer Output alternate function.
the appropriate input transition occurs.
(a) Disable the timer.
(b) Configure the timer for CONTINUOUS mode.
(c) Set the prescale value.
(d) If using the Timer Output alternate function, set the initial output level (High or
Low) via the
Low) through
TPOL
TPOL
bit.
.
(Reload Value – Start Value + 1) x Prescaler
System Clock Frequency (Hz)
Z8FMC16100 Series Flash MCU
Product Specification
Timer Operating Modes
0001h
,
93

Related parts for z8fmc16100