SAM9XE512 Atmel Corporation, SAM9XE512 Datasheet - Page 454

• Manufacturer Part Number: SAM9XE512
• Manufacturer: Atmel Corporation

Specifications of SAM9XE512

• Flash (kbytes): 512 Kbytes
• Pin Count: 217
• Max. Operating Frequency: 180 MHz
• Cpu: ARM926
• Hardware Qtouch Acquisition: No
• Max I/o Pins: 96
• Ext Interrupts: 96
• Usb Transceiver: 3
• Usb Speed: Full Speed
• Usb Interface: Host, Device
• Spi: 2
• Twi (i2c): 2
• Uart: 6
• Ssc: 1
• Ethernet: 1
• Sd / Emmc: 1
• Graphic Lcd: No
• Video Decoder: No
• Camera Interface: Yes
• Adc Channels: 4
• Adc Resolution (bits): 10
• Adc Speed (ksps): 312
• Resistive Touch Screen: No
• Temp. Sensor: No
• Crypto Engine: No
• Sram (kbytes): 32
• Self Program Memory: NO
• External Bus Interface: 1
• Dram Memory: sdram
• Nand Interface: Yes
• Picopower: No
• Temp. Range (deg C): -40 to 85
• I/o Supply Class: 1.8/3.3
• Operating Voltage (vcc): 1.65 to 1.95
• Fpu: No
• Mpu / Mmu: No / Yes
• Timers: 6
• Output Compare Channels: 6
• Input Capture Channels: 6
• 32khz Rtc: Yes
• Calibrated Rc Oscillator: No

While no new data is written in the TWI_THR, the Serial Clock Line is tied low. When new data is
written in the TWI_THR, the SCL is released and the data is sent. To generate a STOP event,
the STOP command must be performed by writing in the STOP field of TWI_CR.
After a Master Write transfer, the Serial Clock line is stretched (tied low) while no new data is
written in the TWI_THR or until a STOP command is performed.
See
Figure
33-6,
Figure
33-7, and
Figure
33-8.
Figure 33-6. Master Write with One Data Byte
STOP Command sent (write in TWI_CR)
TWD
S
DADR
W
A
DATA
A
P
TXCOMP
TXRDY
Write THR (DATA)
Figure 33-7. Master Write with Multiple Data Bytes
STOP command performed
(by writing in the TWI_CR)
TWD
S
DADR
W
A
DATA n
A
DATA n+1
A
DATA n+2
A
P
TWCK
TXCOMP
TXRDY
Write THR (Data n)
Write THR (Data n+1)
Write THR (Data n+2)
Last data sent
AT91SAM9XE128/256/512 Preliminary
454
6254C–ATARM–22-Jan-10