SAM9G45 Atmel Corporation, SAM9G45 Datasheet - Page 218

• Manufacturer Part Number: SAM9G45
• Manufacturer: Atmel Corporation

Specifications of SAM9G45

• Flash (kbytes): 0 Kbytes
• Pin Count: 324
• Max. Operating Frequency: 400 MHz
• Cpu: ARM926
• Hardware Qtouch Acquisition: No
• Max I/o Pins: 160
• Ext Interrupts: 160
• Usb Transceiver: 3
• Usb Speed: Hi-Speed
• Usb Interface: Host, Device
• Spi: 2
• Twi (i2c): 2
• Uart: 5
• Lin: 4
• Ssc: 2
• Ethernet: 1
• Sd / Emmc: 2
• Graphic Lcd: Yes
• Video Decoder: No
• Camera Interface: Yes
• Adc Channels: 8
• Adc Resolution (bits): 10
• Adc Speed (ksps): 440
• Resistive Touch Screen: Yes
• Temp. Sensor: No
• Crypto Engine: No
• Sram (kbytes): 64
• Self Program Memory: NO
• External Bus Interface: 2
• Dram Memory: DDR2/LPDDR, SDRAM/LPSDR
• Nand Interface: Yes
• Picopower: No
• Temp. Range (deg C): -40 to 85
• I/o Supply Class: 1.8/3.3
• Operating Voltage (vcc): 0.9 to 1.1
• Fpu: No
• Mpu / Mmu: No/Yes
• Timers: 6
• Output Compare Channels: 6
• Input Capture Channels: 6
• Pwm Channels: 4
• 32khz Rtc: Yes
• Calibrated Rc Oscillator: No

CP15 Test and Debug Registers
B.1.5
B-12
Cache Debug Control Register
31
The data to be written or read is placed in ARM register Rd with the format shown in
Figure B-4 on page B-8.
The Cache Debug Control Register is used to force specific cache behavior required for
debug.
The following instructions can be used to access the Cache Debug Control Register:
The Cache Debug Control Register format is shown in Figure B-7.
The Cache Debug Control Register bit assignments are listed in Table B-9. The reset
value of the Cache Debug Control Register is
Bit
[31:3]
[2]
[1]
[0]
Copyright © 2001-2003 ARM Limited. All rights reserved.
Name
-
DWB
DIL
DDL
Function
Reserved
Disable write-back (force WT)
Disable ICache linefill
Disable DCache linefill
Table B-9 Cache Debug Control Register bit assignments
SBZ
Figure B-7 Cache Debug Control Register format
.
Description
Read = Unpredictable
Write = Should Be Zero
0 = Enable write-back behavior
1 = Force write-through behavior
0 = Enable ICache linefills
1 = Disable ICache linefills
0 = Enable DCache linefills
1 = Disable DCache linefills
DWB
DDL
DIL
ARM DDI0198D
3
2
1
0