SAM7X256 Atmel Corporation, SAM7X256 Datasheet - Page 450

• Manufacturer Part Number: SAM7X256
• Manufacturer: Atmel Corporation

Specifications of SAM7X256

• Flash (kbytes): 256 Kbytes
• Pin Count: 100
• Max. Operating Frequency: 55 MHz
• Cpu: ARM7TDMI
• Hardware Qtouch Acquisition: No
• Max I/o Pins: 62
• Ext Interrupts: 62
• Usb Transceiver: 1
• Usb Speed: Full Speed
• Usb Interface: Device
• Spi: 2
• Twi (i2c): 1
• Uart: 3
• Can: 1
• Ssc: 1
• Ethernet: 1
• Graphic Lcd: No
• Video Decoder: No
• Camera Interface: No
• Adc Channels: 8
• Adc Resolution (bits): 10
• Adc Speed (ksps): 384
• Resistive Touch Screen: No
• Temp. Sensor: No
• Crypto Engine: No
• Sram (kbytes): 64
• Self Program Memory: NO
• Dram Memory: No
• Nand Interface: No
• Picopower: No
• Temp. Range (deg C): -40 to 85
• I/o Supply Class: 3.3
• Operating Voltage (vcc): 3.0 to 3.6
• Fpu: No
• Mpu / Mmu: no / no
• Timers: 3
• Output Compare Channels: 3
• Input Capture Channels: 3
• Pwm Channels: 4
• 32khz Rtc: Yes
• Calibrated Rc Oscillator: No

34.4
34.4.1
34.4.2
450
Typical Connection
SAM7X512/256/128
USB Device Transceiver
VBUS Monitoring
Figure 34-2. Board Schematic to Interface USB Device Peripheral
The USB device transceiver is embedded in the product. A few discrete components are
required as follows:
Pullup enable/disable is done through a MOSFET controlled by a PIO. The pullup is enabled
when the PIO drives a 0. Thus PIO default state to 1 corresponds to a pullup disable. Once the
pullup is enabled, the host will force a device reset 100 ms later. Bus powered devices must
connect the pullup within 100 ms.
VBUS monitoring is required to detect host connection. VBUS monitoring is done using a stan-
dard PIO with internal pullup disabled. When the host is switched off, it should be considered as
a disconnect, the pullup must be disabled in order to prevent powering the host through the pull-
up resistor.
When the host is disconnected and the transceiver is enabled, then DDP and DDM are floating.
This may lead to over consumption. A solution is to connect 330 KΩ pulldowns on DP and DM.
These pulldowns do not alter DDP and DDM signal integrity.
PIO
PIO
DDM
DDP
• the application detects all device states as defined in chapter 9 of the USB specification;
• to reduce power consumption the host is disconnected
• for line termination.
– pullup enable/disable
– VBUS monitoring
5V Bus Monitoring
Pullup Control
0: Enable
1: Disable
47 K
27 K
R
R
EXT
EXT
330 K
330 K
3V3
1.5K
2
3
Connector
Type B
6120I–ATARM–06-Apr-11
1
4