SAM7X256 Atmel Corporation, SAM7X256 Datasheet - Page 293

• Manufacturer Part Number: SAM7X256
• Manufacturer: Atmel Corporation

Specifications of SAM7X256

• Flash (kbytes): 256 Kbytes
• Pin Count: 100
• Max. Operating Frequency: 55 MHz
• Cpu: ARM7TDMI
• Hardware Qtouch Acquisition: No
• Max I/o Pins: 62
• Ext Interrupts: 62
• Usb Transceiver: 1
• Usb Speed: Full Speed
• Usb Interface: Device
• Spi: 2
• Twi (i2c): 1
• Uart: 3
• Can: 1
• Ssc: 1
• Ethernet: 1
• Graphic Lcd: No
• Video Decoder: No
• Camera Interface: No
• Adc Channels: 8
• Adc Resolution (bits): 10
• Adc Speed (ksps): 384
• Resistive Touch Screen: No
• Temp. Sensor: No
• Crypto Engine: No
• Sram (kbytes): 64
• Self Program Memory: NO
• Dram Memory: No
• Nand Interface: No
• Picopower: No
• Temp. Range (deg C): -40 to 85
• I/o Supply Class: 3.3
• Operating Voltage (vcc): 3.0 to 3.6
• Fpu: No
• Mpu / Mmu: no / no
• Timers: 3
• Output Compare Channels: 3
• Input Capture Channels: 3
• Pwm Channels: 4
• 32khz Rtc: Yes
• Calibrated Rc Oscillator: No

6120I–ATARM–06-Apr-11
Figure 29-18. TWI Read Operation with Multiple Data Bytes with or without Internal Address
No
Read Receive Holding register (TWI_RHR)
Read Receive Holding register (TWI_RHR)
(CLDIV, CHDIV, CKDIV) in TWI_CWGR
- Internal address size (if IADR used)
Set the Master Mode register:
Read ==> bit MREAD = 1
Internal address size = 0?
Set the Control register:
- Device slave address
- Transfer direction bit
Read Status register
Read Status register
Read status register
(Needed only once)
TWI_CR = MSEN
TWI_CR = START
TWI_CR = STOP
Yes
Last data to read
Start the transfer
Stop the transfer
- Master enable
TXCOMP = 1?
Set TWI clock
RXRDY = 1?
Yes
Yes
Yes
RXRDY = 1?
Yes
but one?
BEGIN
END
SAM7X512/256/128
No
No
No
Set the internal address
TWI_IADR = address
293