SAM7X256 Atmel Corporation, SAM7X256 Datasheet - Page 281

• Manufacturer Part Number: SAM7X256
• Manufacturer: Atmel Corporation

Specifications of SAM7X256

• Flash (kbytes): 256 Kbytes
• Pin Count: 100
• Max. Operating Frequency: 55 MHz
• Cpu: ARM7TDMI
• Hardware Qtouch Acquisition: No
• Max I/o Pins: 62
• Ext Interrupts: 62
• Usb Transceiver: 1
• Usb Speed: Full Speed
• Usb Interface: Device
• Spi: 2
• Twi (i2c): 1
• Uart: 3
• Can: 1
• Ssc: 1
• Ethernet: 1
• Graphic Lcd: No
• Video Decoder: No
• Camera Interface: No
• Adc Channels: 8
• Adc Resolution (bits): 10
• Adc Speed (ksps): 384
• Resistive Touch Screen: No
• Temp. Sensor: No
• Crypto Engine: No
• Sram (kbytes): 64
• Self Program Memory: NO
• Dram Memory: No
• Nand Interface: No
• Picopower: No
• Temp. Range (deg C): -40 to 85
• I/o Supply Class: 3.3
• Operating Voltage (vcc): 3.0 to 3.6
• Fpu: No
• Mpu / Mmu: no / no
• Timers: 3
• Output Compare Channels: 3
• Input Capture Channels: 3
• Pwm Channels: 4
• 32khz Rtc: Yes
• Calibrated Rc Oscillator: No

29. Two-wire Interface (TWI)
29.1
29.2
6120I–ATARM–06-Apr-11
Overview
Block Diagram
The Two-wire Interface (TWI) interconnects components on a unique two-wire bus, made up of
one clock line and one data line with speeds of up to 400 Kbits per second, based on a byte-ori-
ented transfer format. It can be used with any Atmel Two-wire Interface bus Serial EEPROM and
I²C compatible device such as Real Time Clock (RTC), Dot Matrix/Graphic LCD Controllers and
Temperature Sensor, to name but a few. The TWI is programmable as master transmitter or
master receiver with sequential or single-byte access. A configurable baud rate generator per-
mits the output data rate to be adapted to a wide range of core clock frequencies. Below,
29-1
Table 29-1.
Notes:
Figure 29-1. Block Diagram
I2C Standard
Standard Mode Speed (100 KHz)
Fast Mode Speed (400 KHz)
7 or 10 bits Slave Addressing
START BYTE
Repeated Start (Sr) Condition
ACK and NACK Management
Slope control and input filtering (Fast mode)
Clock strectching
lists the compatibility level of the Atmel Two-wire Interface and a full I2C compatible device.
1. START + b000000001 + Ack + Sr
2. A repeated start condition is only supported in Master Receiver mode. See
”Internal Address” on page 286
(1)
Atmel TWI compatibility with i2C Standard
PMC
APB Bridge
MCK
Two-wire
Interface
Atmel TWI
Supported
Supported
Supported
Not Supported
Not Fully Supported
Supported
Not Supported
Supported
Interrupt
TWI
SAM7X512/256/128
PIO
AIC
(2)
TWCK
TWD
Section 29.5.5
Table
281