PNX1501E,557 NXP Semiconductors, PNX1501E,557 Datasheet - Page 629

• Manufacturer Part Number: PNX1501E,557
• Description: IC MEDIA PROC 266MHZ 456-BGA
• Manufacturer: NXP Semiconductors

Specifications of PNX1501E,557

• Applications: Multimedia
• Core Processor: TriMedia
• Controller Series: Nexperia
• Interface: I²C, 2-Wire Serial
• Number Of I /o: 61
• Voltage - Supply: 1.14 V ~ 1.26 V
• Operating Temperature: 0°C ~ 85°C
• Mounting Type: Surface Mount
• Package / Case: 456-BGA
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Program Memory Type: -
• Ram Size: -
• Other names: 935274728557; PNX1501E; PNX1501E

Philips Semiconductors
Volume 1 of 1
4. Register Descriptions
PNX15XX_SER_3
Product data sheet
In 32-bit per pixel mode, all 256 bytes of each scanline of the PatRam are used. The
host must load the entire PatRam prior to initiating a BLT that uses a pattern. In this
mode, bytes 0..3 of the PatRam are the upper left pixel in the ram. Byte 0 is the LSB
of the pixel and contains the blue component, byte 1 contains the green component,
byte two contains the red component, and byte three is the alpha component (usually
unused).
The PatRam can be loaded in two different ways to load either color data or
monochrome data.
The 256 byte PatRamColor section of the register space allows direct byte/word/
DWORD
pixels of data must be loaded into the PatRam prior to use. This ranges from 64 to
256 bytes of data depending on color depth. Byte 0 of this space is the first byte of
PatRam scanline 0.
To assist in loading mono patterns, the 8 byte PatRamMono section of the register
space provides automatic color expansion of mono data while loading the PatRam.
Thus, the host only sends 16 bytes (four
pattern regardless of color depth: MonPatFColor, MonoPatBColor, and 8 bytes of
mono data (64 bits). Each bit in the mono data stream loads the appropriate byte(s)
of the PatRam with either the foreground color if the bit is a 1, or else the background
color if the bit is a 0. Byte0/Bit7 loads the left pixel of scanline 0, byte1/Bit7 loads the
left pixel of scanline 1, etc.
The drawing engine uses five areas of memory space:
1. The first memory space area is for the drawing engine command registers. These
2. The next area decoded is for monochrome pattern data. Although only 8 bytes of
3. The third decoded area is for full color pattern data. 64, 128, or 256 bytes of data
4. The fourth area decoded is for “real time” drawing registers. Unlike command
5. The last memory area decoded is a 64-KB area that is used to transfer host data
registers are used to set up and execute drawing engine commands. There is a
block of unused memory space that has been reserved for future drawing engine
functions.
monochrome pattern data are required, a 256-byte decode is implemented to
allow color expansion to occur to different areas of the pattern RAM.
may be written to the pattern RAM.
registers which are pipelined, real time registers can be accessed immediately.
to the drawing engine.
access to the PatRam. This allows arbitrary pattern data to be loaded. 64
Rev. 3 — 17 March 2006
DWORDS
) of data to initialize the entire
Chapter 20: 2D Drawing Engine
© Koninklijke Philips Electronics N.V. 2006. All rights reserved.
PNX15xx Series
20-13