PNX1501E,557 NXP Semiconductors, PNX1501E,557 Datasheet - Page 497

• Manufacturer Part Number: PNX1501E,557
• Description: IC MEDIA PROC 266MHZ 456-BGA
• Manufacturer: NXP Semiconductors

Specifications of PNX1501E,557

• Applications: Multimedia
• Core Processor: TriMedia
• Controller Series: Nexperia
• Interface: I²C, 2-Wire Serial
• Number Of I /o: 61
• Voltage - Supply: 1.14 V ~ 1.26 V
• Operating Temperature: 0°C ~ 85°C
• Mounting Type: Surface Mount
• Package / Case: 456-BGA
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Program Memory Type: -
• Ram Size: -
• Other names: 935274728557; PNX1501E; PNX1501E

Philips Semiconductors
Volume 1 of 1
PNX15XX_SER_3
Product data sheet
Figure 7:
fgpi_d_valid
fgpi_start
fgpi_stop
fgpi_data
clk_fgpi
Back-to-back Message Passing Example
3.2.1 Minimum Message/Record Size
XXXXX
3.2 Message Passing Mode
Only active clock edges where fgpi_d_valid is asserted ‘1’ allow data samples to be
captured.
If FGPI_REC_SIZE is not a multiple of 4 bytes, the message will be written to main
memory as a series of 32-bit words. Only the last word is padded with zeroes in the
unused bit positions.
Message start is signaled on the fgpi_start pin and message stop is signaled on the
fgpi_stop pin. See FGPI_CTL.MSG_START and FGPI_CTL.MSG_STOP for
selecting which edge will be active.
Figure 7
start event is set to the falling edge of fgpi_start and the message stop event is set to
the rising edge of fgpi_stop.
Message mode requires both fgpi_start and fgpi_stop signals to operate. There is no
external buffer sync available. Buffers are switched when the number of messages
received equals the value programmed into the FGPI_SIZE register.
If the incoming message length is greater than the value programmed into the
FGPI_REC_SIZE register, the message is truncated and the OVERFLOW interrupt is
generated (if enabled).
THE MINIMUM MESSAGE SIZE is 2, that is, FGPI_REC_SIZE must be programmed
greater than 1.
There is a limit to the message size when back-to-back messages are received.
If the sample size is 32-bits AND TSTAMP_SELECT = ‘1’ AND VAR_LENGTH =
‘1’ then the minimum message size is 3 (due to the insertion of 2 32-bit words into
the message packet).
D1
illustrates an example of a two 8-sample message transfer. The message
D2
Rev. 3 — 17 March 2006
D3
Chapter 14: FGPI: Fast General Purpose Interface
D4
D5
D6
© Koninklijke Philips Electronics N.V. 2006. All rights reserved.
D7
PNX15xx Series
D8
XXX
14-14