R5F21324ANSP#U1 Renesas Electronics America, R5F21324ANSP#U1 Datasheet - Page 388

• Manufacturer Part Number: R5F21324ANSP#U1
• Description: MCU 1KB FLASH 16K ROM 20-LSSOP
• Manufacturer: Renesas Electronics America
• Series: R8C/3x/32Ar

Specifications of R5F21324ANSP#U1

• Core Processor: R8C
• Core Size: 16/32-Bit
• Speed: 20MHz
• Connectivity: I²C, LIN, SIO, SSU, UART/USART
• Peripherals: POR, PWM, Voltage Detect, WDT
• Number Of I /o: 15
• Program Memory Size: 16KB (16K x 8)
• Program Memory Type: FLASH
• Ram Size: 1.5K x 8
• Voltage - Supply (vcc/vdd): 1.8 V ~ 5.5 V
• Data Converters: A/D 4x10b
• Oscillator Type: Internal
• Operating Temperature: -20°C ~ 85°C
• Package / Case: 20-LSSOP
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Eeprom Size: -

Under development
R8C/32A Group
REJ09B0458-0020 Rev.0.20
Page 358 of 583
22.7.2
22.7.3
22.7.2.1
22.7.2.2
When the RTS function is used with an external clock, the RTS2 pin outputs “L,” which informs the
transmitting side that the MCU is ready for a receive operation. The RTS2 pin outputs “H” when a receive
operation starts. Therefore, the transmit timing and receive timing can be synchronized by connecting the RTS2
pin to the CTS2 pin of the transmitting side. The RTS function is disabled when an internal clock is selected.
If an external clock is selected, the following conditions must be met while the external clock is held high when
the CKPOL bit in the U2C0 register is set to 0 (transmit data output at the falling edge and receive data input at
the rising edge of the transfer clock), or while the external clock is held low when the CKPOL bit is set to 1
(transmit data output at the rising edge and receive data input at the falling edge of the transfer clock).
• The TE bit in the U2C1 register = 1 (transmission enabled)
• The TI bit in the U2C1 register = 0 (data present in the U2TB register)
• If the CTS function is selected, input on the CTS2 pin = “L”
When generating start, stop, and restart conditions, set the STSPSEL bit in the U2SMR4 register to 0 and wait
for more than half cycle of the transfer clock before changing each condition generation bit (STAREQ,
RSTAREQ, and STPREQ) from 0 to 1.
Clock Asynchronous Serial I/O (UART) Mode
Special Mode 1 (I
Transmission/Reception
Transmission
Preliminary specification
Specifications in this manual are tentative and subject to change.
Nov 05, 2008
2
C Mode)
22. Serial Interface (UART2)