PNX1700EH,557 NXP Semiconductors, PNX1700EH,557 Datasheet - Page 208

• Manufacturer Part Number: PNX1700EH,557
• Manufacturer: NXP Semiconductors

Specifications of PNX1700EH,557

• Operating Temperature (min): 0C
• Operating Temperature Classification: Commercial
• Mounting: Surface Mount
• Lead Free Status / RoHS Status: Not Compliant

Philips Semiconductors
Volume 1 of 1
Table 1: The Boot Modes
PNX17XX_SER_1
Preliminary data sheet
BOOT_MODE
Bits
3
2
1:0
GPIO
pins
3
2
1:0
…Continued
Default Function
0x0
0x1
0x3
The default state of the BOOT_MODE[3:0] pins may be determined by the internal
pull-ups and pull-downs presents in the I/Os of PNX17xx Series. However the
BOOT_MODE[7:4] pins must be pulled up or down at board level to ensure a proper
boot function.
CAS_LATENCY DDR SDRAM devices support different types of CAS latencies.
ROM_WIDTH/
IIC_FASTMODE
BOOT_MODE
Rev. 1 — 17 March 2006
Description
However they do not support all the combinations. PNX17xx
Series offers the possibility to program the MMI (and therefore the
DDR SDRAM devices) with the appropriate CAS latency at boot
time. This is crucial for standalone boot from Flash memories
devices since 8 Kilobytes of data is stored into the main memory
during the execution of the boot scripts.
0 - 2.5 clock periods
1 - 3 clocks periods
This pin has a dual functional mode:
If BOOT_MODE[1:0] = “00”, “01”, or “10” (Boot from Flash
memory)
0 - 8-bit data wide ROM
1 - 16-bit data wide ROM
If BOOT_MODE[1:0] = “11” (Boot from I
0 - 100 KHz
1 - 400 KHz
The main boot mode is determined as follows:
00 - Set up the system and start the TM5250 CPU from a 8- or 16-
bit NOR Flash memory or ROM attached to the PCI-XIO bus.
01 - Set up the system and start the TM5250 CPU from a 8- or 16-
bit NAND Flash memory or ROM attached to the PCI-XIO bus.
10 - Set up the PNX17xx Series system in host-assisted mode
and allow the host CPU to finish the configuration of the PNX17xx
Series system and start the TM5250 CPU.
11 - Boot from an I
EEPROMs of 2 to 64 Kilobytes are supported. The entire system
can be initialized in a custom fashion by the boot commands
contained in the EEPROM. This mode can be used for standalone
or host-assisted boot mode when the other internal boot scripts
are not meeting the specific requirements of the application. In
this mode the boot script is in the EEPROM. Refer to
for further details on the EEPROM content.
2
C EEPROM attached to the I
© Koninklijke Philips Electronics N.V. 2006. All rights reserved.
PNX17xx Series
Chapter 6: Boot Module
2
C EEPROM)
2
C interface.
Section 2.3
6-3