C8051F996DK Silicon Laboratories Inc, C8051F996DK Datasheet - Page 17

• Manufacturer Part Number: C8051F996DK
• Description: KIT DEV FOR C8051F996
• Manufacturer: Silicon Laboratories Inc
• Type: MCUr

Specifications of C8051F996DK

• Contents: Board, Batteries, Cables, CDs, Debug Adapter, Documentation, Power Adapter
• Processor To Be Evaluated: C8051F996
• Processor Series: C8051F98x
• Interface Type: USB
• Operating Supply Voltage: 3 V
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• For Use With/related Products: C8051F996
• Lead Free Status / Rohs Status: Lead free / RoHS Compliant
• Other names: 336-1963

1.
C8051F99x-C8051F98x devices are fully integrated mixed-signal system-on-a-chip MCUs. Highlighted
features are listed below. Refer to Table 2.1 for specific product feature selection and part ordering
numbers.















With on-chip power-on reset, V
C8051F98x devices are truly stand-alone system-on-a-chip solutions. The Flash memory can be
reprogrammed even in-circuit, providing non-volatile data storage, and also allowing field upgrades of the
8051 firmware. User software has complete control of all peripherals, and may individually shut down any
or all peripherals for power savings.
The on-chip Silicon Labs 2-Wire (C2) Development Interface allows non-intrusive (uses no on-chip
resources), full speed, in-circuit debugging using the production MCU installed in the final application. This
debug logic supports inspection and modification of memory and registers, setting breakpoints, single
stepping, run and halt commands. All analog and digital peripherals are fully functional while debugging
using C2. The two C2 interface pins can be shared with user functions, allowing in-system debugging
without occupying package pins.
Each device is specified for 1.8 to 3.6 V operation over the industrial temperature range (–40 to +85 °C).
The Port I/O and RST pins are powered from the supply voltage. The C8051F99x-C8051F98x devices are
available in 20-pin or 24-pin QFN or 24-pin QSOP packages. All package options are lead-free and RoHS
compliant. See Table 2.1 for ordering information. Block diagrams are included in Figure 1.1 through
Figure 1.9.
Ultra low power consumption in active and sleep modes.
High-speed pipelined 8051-compatible microcontroller core (up to 25 MIPS)
In-system, full-speed, non-intrusive debug interface (on-chip)
10-bit 300 ksps or 12-bit 75 ksps single-ended ADC with analog multiplexer
6-bit programmable current reference (resolution can be increased with PWM)
Precision programmable 24.5 MHz internal oscillator with spread spectrum technology.
8 kB , 4 kB, or 2 kB of on-chip Flash memory
512 bytes of on-chip RAM
SMBus/I
Four general-purpose 16-bit timers
Programmable counter/timer array (PCA) with three capture/compare modules and watchdog timer
function
On-chip power-on reset, V
One on-chip voltage comparator
Up to 14 Capacitive Touch (QuickSense™) Inputs
Up to 17 Port I/O
System Overview
2
C, Enhanced UART, and Enhanced SPI serial interfaces implemented in hardware
DD
monitor, and temperature sensor
DD
monitor, watchdog timer, and clock oscillator, the C8051F99x-
Rev. 1.0
C8051F99x-C8051F98x
17