PEB2256E INFINEON [Infineon Technologies AG], PEB2256E Datasheet - Page 191

• Manufacturer Part Number: PEB2256E
• Description: E1/T1/J1 Framer and Line Interface Component for Long and Short Haul Applications
• Manufacturer: INFINEON [Infineon Technologies AG]

Table 47
Operational Set Up
Select framing
Framing additions
Synchronization mode
Signaling mode
Features like channel loop-back, idle channel activation, extensions for signaling
support, alarm simulation, etc. are activated later. Transmission of alarms (e.g. AIS,
remote alarm) and control of synchronization in connection with consequent actions to
remote end and internal system depend on the activation procedure selected.
Note: Read access to unused register addresses: value should be ignored.
Specific E1 Register Settings
The following is a suggestion for a basic initialization to meet most of the E1
requirements. Depending on different applications and requirement any other
initialization can be used.
Table 48
FMR0.XC0/
FMR0.RC0/
LIM1.DRS
FMR3.CMI
PCD = 0A
PCR = 15
LIM1.RIL(2:0) = 02
E1 Framer Initialization
The selection of the following modes during the basic initialization supports the ETSI
requirements for E-Bit Access, remote alarm and synchronization (please refer also to
FALC56 driver code of the evaluation system EASY22554 and application notes) and
Data Sheet
Write access to unused register addresses: should be avoided, or set to “00” hex.
All control registers (except XFIFO, XS(16:1), CMDR, DEC) are of type Read/
Write.
H
H
Initialization Parameters (E1) (cont’d)
Line Interface Initialization (E1)
H
The FALC56 supports requirements for the analog line interface
as well as the digital line interface. For the analog line interface
the codes AMI and HDB3 are supported. For the digital line
interface modes (dual- or single-rail) the FALC56 supports AMI,
HDB3, CMI (with and without HDB3 precoding) and NRZ.
LOS detection after 176 consecutive “zeros” (fulfills G.775).
LOS recovery after 22 “ones” in the PCD interval. (fulfills G.775).
LOS threshold of 0.6 V (fulfills G.775).
191
FMR2.RFS(1:0), FMR1.XFS
RC1.ASY4, RC1.SWD
FMR1.AFR, FMR2.ALMF
XSP, XSW, FMR1.ENSA, XSA(8:4),
TSWM, MODE, CCR1, CCR2, RAH(2:1),
RAL(2:1)
Operational Description E1
FALC56 V1.2
PEB 2256
2002-08-27