PEB2256E INFINEON [Infineon Technologies AG], PEB2256E Datasheet - Page 142

• Manufacturer Part Number: PEB2256E
• Description: E1/T1/J1 Framer and Line Interface Component for Long and Short Haul Applications
• Manufacturer: INFINEON [Infineon Technologies AG]

Figure 49 gives an overview of influences on synchronization status for the case of
different external actions. Activation of auto mode and non-auto mode is performed by
bit FMR4.AUTO. Generally, for initiating resynchronization it is recommended to use bit:
FMR0.EXLS first. In cases where the synchronizer remains in the asynchronous state,
bit FMR0.FRS is used to enforce it to lock onto the next framing candidate, although it
might be a simulated one.
5.2.4
The allocation of the FT-bits (bit 1 of frames 1 and 3) for frame alignment signal is shown
in
The FS-bit can be used for signaling. Remote alarm (yellow alarm) is indicated by setting
bit 2 to 0 in each time slot.
Table 33
Frame Number
1
2
3
4
5.2.4.1
For multiframe synchronization, the terminal framing bits (FT-bits) are observed. The
synchronous state is reached if at least one terminal framing candidate is definitely
found, or the synchronizer is forced to lock onto the next available candidate
(FMR0.FRS).
Data Sheet
Table
33.
4-Frame Multiframe (F4 Format, T1/J1)
Synchronization Procedure
4-Frame Multiframe Structure (T1/J1)
F
1
–
0
–
T
142
Functional Description T1/J1
F
service bit
service bit
S
FALC56 V1.2
PEB 2256
2002-08-27