LAN9420I-NU Standard Microsystems (SMSC), LAN9420I-NU Datasheet - Page 111

• Manufacturer Part Number: LAN9420I-NU
• Manufacturer: Standard Microsystems (SMSC)

Specifications of LAN9420I-NU

• Operating Supply Voltage (typ): 3.3V
• Operating Supply Voltage (min): 3V
• Operating Supply Voltage (max): 3.6V
• Operating Temperature Classification: Industrial
• Mounting: Surface Mount
• Pin Count: 128
• Lead Free Status / RoHS Status: Compliant

Single-Chip Ethernet Controller with HP Auto-MDIX Support and PCI Interface
Datasheet
SMSC LAN9420/LAN9420i
4.3.7
31:23
19:16
15:14
BITS
12:3
22
21
13
2
RESERVED
RESERVED
Must Be One (MBO)
This bit must be set to ‘1’ for normal device operation.
RESERVED
RESERVED
Start/Stop Transmission Command (ST)
When set, the transmission process is placed in the Running state, and the
DMAC checks the transmit list at the current position for a frame to be
transmitted.
Descriptor acquisition is attempted either from the current position in the list,
which is the transmit list base address set by TX_BASE_ADDR, or from the
position retained when the transmit process was previously stopped. If no
descriptor can be acquired, the transmit process enters the Suspended
state. If the current descriptor is not owned by the DMA Controller, the
transmission process enters the Suspended state and the Transmit Buffer
Unavailable (DMAC_STATUS bit [2]) is set. The Start Transmission
command is effective only when the transmission process is stopped. If the
command is issued before setting the TX_BASE_ADDR, then the DMA
Controller’s behavior will be undefined.
When reset, the transmission process is placed in the Stopped state after
completing the transmission of the current frame. The next descriptor
position in the transmit list is saved, and becomes the current position when
transmission is restarted.
The Stop Transmission command is effective only when the transmission
process is in either Running or Suspended state.
RESERVED
Operate on Second Frame (OSF)
When set, this bit instructs the DMA Controller to process a second frame
of transmit data even before status for the first frame is obtained. This bit
affects the DMA Controller but not the MIL.
DMA Controller Control (Operation Mode) Register (DMAC_CONTROL)
This register establishes the RX and TX operating modes and commands. This should be the last
DCSR written as part of initialization.
Offset:
DESCRIPTION
0018h
DATASHEET
111
Size:
32 bits
TYPE
R/W
R/W
R/W
R/W
R/W
RO
RO
RO
Revision 1.4 (12-17-08)
DEFAULT
00b
0b
0b
0b
0b
-
-
-