ST10F280 STMicroelectronics, ST10F280 Datasheet - Page 32

• Manufacturer Part Number: ST10F280
• Description: MCU 16BIT 512K FLASH MAC 208-PBG
• Manufacturer: STMicroelectronics
• Series: ST10r

Specifications of ST10F280

• Core Processor: ST10
• Core Size: 16-Bit
• Speed: 40MHz
• Connectivity: ASC, CAN, EBI/EMI, SSC
• Peripherals: POR, PWM, WDT
• Number Of I /o: 143
• Program Memory Size: 512KB (512K x 8)
• Program Memory Type: FLASH
• Ram Size: 18K x 8
• Voltage - Supply (vcc/vdd): 4.5 V ~ 5.5 V
• Data Converters: A/D 32x10b
• Oscillator Type: Internal
• Operating Temperature: -40°C ~ 125°C
• Package / Case: 208-PBGA
• Processor Series: ST10F28x
• Core: ST10
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Eeprom Size: -
• Lead Free Status / Rohs Status: Details

ST10F280
POP
EXTS
MOV
Data_Polling:
EXTS
MOV
MOV
XOR
JNB
JNB
EXTS
MOV
XOR
JNB
Prog_Error:
MOV
EXTS
MOV
...
...
...
Prog_OK:
....
....
32/186
DPP0
R11, #1
[R12], R13
R11, #1
R7, [R12]
R6, R7
R7, R13
R7.7, Prog_OK
R6.5, Data_Polling
R11, #1
R7, [R12]
R7, R13
R7.7, Prog_OK
R7, #0F0h
R11, #1
[R12], R7
;restore DPP0: following addressing to the Flash
;will use EXTended instructions
;R11 contains the segment to be programmed
;R12 contains the segment offset address to be
;programmed
;R13 contains the data to be programmed
;use EXTended addressing for next MOV instruction
;command cycle 4: the EPC starts execution of
;Programming Command
;use EXTended addressing for next MOV instruction
;read Flash Status register (FSB) in R7
;save it in R6 register
;Check if FSB.7 = Data.7 (i.e. R7.7 = R13.7)
;Check if FSB.5 = 1 (Programming Error)
;Programming Error: verify is Flash programmed
;data is OK
;use EXTended addressing for next MOV instruction
;read Flash Status register (FSB) in R7
;Check if FSB.7 = Data.7
;Programming failed: Flash remains in Write
;Operation.
;To go back to normal Read operations, a Read/Reset
;command
;must be performed
;load register R7 with Read/Reset command
;use EXTended addressing for next MOV instruction
;address is don’t care for Read/Reset command
;here place specific Error handling code
;When programming operation finished succesfully,
;Flash is set back automatically to normal Read Mode