MCP1631RD-DCPC1 Microchip Technology, MCP1631RD-DCPC1 Datasheet - Page 125

• Manufacturer Part Number: MCP1631RD-DCPC1
• Description: REF DES BATT CHARG OR LED DRIVER
• Manufacturer: Microchip Technology

Specifications of MCP1631RD-DCPC1

• Current - Output / Channel: 700mA
• Outputs And Type: 1, Non-Isolated
• Features: Firmware for Li-Ion, NiMH, and NiCd Battery Charger
• Voltage - Input: 3.5 ~ 16 V
• Utilized Ic / Part: MCP1631HV, PIC16F616
• Core Chip: MCP1631HV, PIC16F616
• Topology: Parallel, Series
• Output Current: 1A
• No. Of Outputs: 1
• Input Voltage: 3.5V To 16V
• Dimming Control Type: Analog
• Kit Contents: Board
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Voltage - Output: -
• Lead Free Status / Rohs Status: Lead free / RoHS Compliant

FIGURE 12-9:
12.8
If
programmed, the on-chip program memory can be
read out using ICSP
12.9
Four memory locations (2000h-2003h) are designated
as ID locations where the user can store checksum or
other code identification numbers. These locations are
not accessible during normal execution but are
readable and writable during Program/Verify mode.
Only the Least Significant 7 bits of the ID locations are
used.
© 2009 Microchip Technology Inc.
Instruction Flow
(INTCON reg.)
(INTCON reg.)
Note:
Instruction
Fetched
Instruction
Executed
the
CLKOUT
Note 1:
INTF flag
INT pin
GIE bit
OSC1
Code Protection
ID Locations
code
PC
2:
3:
4:
(4)
The entire Flash program memory will be
erased when the code protection is turned
off.
Specification
information.
XT, HS or LP Oscillator mode assumed.
T
GIE = ‘1’ assumed. In this case after wake-up, the processor jumps to 0004h. If GIE = ‘0’, execution will continue in-line.
CLKOUT is not available in XT, HS, LP or EC Oscillator modes, but shown here for timing reference.
Q1 Q2 Q3 Q4 Q1 Q2 Q3 Q4 Q1
Inst(PC) = Sleep
OST
protection
Inst(PC – 1)
See
= 1024 T
PC
™
WAKE-UP FROM SLEEP THROUGH INTERRUPT
for verification purposes.
the
OSC
(DS41284)
(drawing not to scale). This delay does not apply to EC, INTOSC and RC Oscillator modes.
bit(s)
Memory
Inst(PC + 1)
Sleep
PC + 1
have
Programming
for
Processor in
PIC16F610/616/16HV610/616
not
Sleep
more
PC + 2
been
T
OST (2)
Q1 Q2 Q3 Q4 Q1 Q2 Q3 Q4 Q1 Q2 Q3 Q4 Q1 Q2 Q3 Q4
Interrupt Latency
Inst(PC + 2)
Inst(PC + 1)
PC + 2
(3)
Dummy Cycle
PC + 2
Dummy Cycle
Inst(0004h)
0004h
DS41288F-page 125
Inst(0005h)
Inst(0004h)
0005h