HD6412332 RENESAS [Renesas Technology Corp], HD6412332 Datasheet - Page 842

• Manufacturer Part Number: HD6412332
• Description: Renesas 16-Bit Single-Chip Microcomputer H8S Family/H8S/2300 Series
• Manufacturer: RENESAS [Renesas Technology Corp]

• Before branching to the programming control program (RAM area H'FFE400 to H'FFFBFF),
• Boot mode can be entered by making the pin settings shown in table 19.30 and executing a
• If the mode pin input levels are changed (for example, from low to high) during a reset, the
Notes: 1. Mode pins and FWE pin input must satisfy the mode programming setup time (t
Rev.4.00 Sep. 07, 2007 Page 812 of 1210
REJ09B0245-0400
the chip terminates transmit and receive operations by the on-chip SCI (channel 1) (by clearing
the RE and TE bits in SCR to 0), but the adjusted bit rate value remains set in BRR. The
transmit data output pin, TxD1, goes to the high-level output state (P31DDR = 1, P31DR = 1).
The contents of the CPU’s internal general registers are undefined at this time, so these
registers must be initialized immediately after branching to the programming control program.
In particular, since the stack pointer (SP) is used implicitly in subroutine calls, etc., a stack area
must be specified for use by the programming control program.
Initial settings must also be made for the other on-chip registers.
reset-start.
Boot mode can be cleared by driving the reset pin low, waiting at least 20 states, then setting
the FWE pin and mode pins, and executing reset release *
WDT overflow reset.
Do not change the mode pin input levels in boot mode, and do not drive the FWE pin low
while the boot program is being executed or while flash memory is being programmed or
erased *
state of ports with multiplexed address functions and bus control output pins (AS, RD, HWR)
will change according to the change in the microcomputer’s operating mode *
Therefore, care must be taken to make pin settings to prevent these pins from becoming output
signal pins during a reset, or to prevent collision with signals outside the microcomputer.
2. For further information on FWE application and disconnection, see section 19.21,
3. See section 9, I/O Ports.
2
200 ns) with respect to the reset release timing, as shown in figures 19.56 to 19.58.
Flash Memory Programming and Erasing Precautions.
.
1
. Boot mode can also be cleared by a
3
.
MDS
=