HD6412332 RENESAS [Renesas Technology Corp], HD6412332 Datasheet - Page 228

no-image

HD6412332

Manufacturer Part Number
HD6412332
Description
Renesas 16-Bit Single-Chip Microcomputer H8S Family/H8S/2300 Series
Manufacturer
RENESAS [Renesas Technology Corp]
Datasheet

Available stocks

Company
Part Number
Manufacturer
Quantity
Price
Part Number:
HD6412332
Manufacturer:
SMD
Quantity:
6
Part Number:
HD6412332FC25V
Manufacturer:
ALLEGRO
Quantity:
4 340
Part Number:
HD6412332VFC25V
Manufacturer:
RENESAS/瑞萨
Quantity:
20 000
6.11.3
Even if a bus request is received from a bus master with a higher priority than that of the bus
master that has acquired the bus and is currently operating, the bus is not necessarily transferred
immediately. There are specific times at which each bus master can relinquish the bus.
CPU: The CPU is the lowest-priority bus master, and if a bus request is received from the DTC or
DMAC, the bus arbiter transfers the bus to the bus master that issued the request. The timing for
transfer of the bus is as follows:
• The bus is transferred at a break between bus cycles. However, if a bus cycle is executed in
• If the CPU is in sleep mode, it transfers the bus immediately.
DTC: The DTC sends the bus arbiter a request for the bus when an activation request is generated.
The DTC can release the bus after a vector read, a register information read (3 states), a single data
transfer, or a register information write (3 states). It does not release the bus during a register
information read (3 states), a single data transfer, or a register information write (3 states).
DMAC: The DMAC sends the bus arbiter a request for the bus when an activation request is
generated.
In the case of an external request in short address mode or normal mode, and in cycle steal mode,
the DMAC releases the bus after a single transfer.
In block transfer mode, it releases the bus after transfer of one block, and in burst mode, after
completion of the transfer.
6.11.4
External bus release can be performed on completion of an external bus cycle. The RD signal and
the DRAM interface RAS and CAS signals remain low until the end of the external bus cycle.
Therefore, when external bus release is performed, the RD, RAS, and CAS signals may change
from the low level to the high-impedance state.
Rev.4.00 Sep. 07, 2007 Page 198 of 1210
REJ09B0245-0400
discrete operations, as in the case of a longword-size access, the bus is not transferred between
the component operations. For details of times when the bus is not transferred, see appendix
A.5, Bus States during Instruction Execution.
Bus Transfer Timing
External Bus Release Usage Note

Related parts for HD6412332