psd835g2 STMicroelectronics, psd835g2 Datasheet - Page 45
![no-image](/images/manufacturer_photos/0/6/637/stmicroelectronics_sml.jpg)
psd835g2
Manufacturer Part Number
psd835g2
Description
Configurable Memory System On A Chip For 8-bit Microcontrollers
Manufacturer
STMicroelectronics
Datasheet
1.PSD835G2.pdf
(120 pages)
Available stocks
Company
Part Number
Manufacturer
Quantity
Price
Company:
Part Number:
psd835g2-70U
Manufacturer:
ON
Quantity:
2 100
Company:
Part Number:
psd835g2-70U
Manufacturer:
STMicroelectronics
Quantity:
10 000
Part Number:
psd835g2-70U
Manufacturer:
ST
Quantity:
20 000
Company:
Part Number:
psd835g2-90U
Manufacturer:
TRIQUINT
Quantity:
22
Part Number:
psd835g2-90U
Manufacturer:
ST
Quantity:
20 000
Company:
Part Number:
psd835g2-90UI
Manufacturer:
ST
Quantity:
201
Company:
Part Number:
psd835g2V-12UI
Manufacturer:
INFINEON
Quantity:
3 392
PSD835G2
9.4
Suspend Sector Erase instruction executed during an Erase time-out period, in addition to
suspending the Erase cycle, terminates the time out period.
The Toggle flag bit (DQ6) stops toggling when the PSD internal logic is suspended. The
status of this bit must be monitored at an address within the Flash memory sector being
erased. The Toggle flag bit (DQ6) stops toggling between 0.1 µs and 15 µs after the
Suspend Sector Erase instruction has been executed. The PSD is then automatically set to
READ mode.
If a Suspend Sector Erase instruction was executed, the following rules apply:
●
●
●
●
Resume Sector Erase
If a Suspend Sector Erase instruction was previously executed, the erase cycle may be
resumed with this instruction. The Resume Sector Erase instruction consists in writing 030h
to any even address while an appropriate Sector Select (FS0-FS7 or CSBOOT0-CSBOOT3)
is high (see
Attempting to read from a Flash memory sector that was being erased outputs invalid
data.
Reading from a Flash sector that was not being erased is valid.
The Flash memory cannot be programmed, and only responds to Resume Sector
Erase and Reset Flash instructions (READ is an operation and is allowed).
If a Reset Flash instruction is received, data in the Flash memory sector that was being
erased is invalid.
Table
7.)
Erasing Flash memory
45/120