ATxmega128A1 Atmel Corporation, ATxmega128A1 Datasheet - Page 52

• Manufacturer Part Number: ATxmega128A1
• Manufacturer: Atmel Corporation

Specifications of ATxmega128A1

• Flash (kbytes): 128 Kbytes
• Pin Count: 100
• Max. Operating Frequency: 32 MHz
• Cpu: 8-bit AVR
• # Of Touch Channels: 16
• Hardware Qtouch Acquisition: No
• Max I/o Pins: 78
• Ext Interrupts: 78
• Usb Speed: No
• Usb Interface: No
• Spi: 12
• Twi (i2c): 4
• Uart: 8
• Graphic Lcd: No
• Video Decoder: No
• Camera Interface: No
• Adc Channels: 16
• Adc Resolution (bits): 12
• Adc Speed (ksps): 2000
• Analog Comparators: 4
• Resistive Touch Screen: No
• Dac Channels: 4
• Dac Resolution (bits): 12
• Temp. Sensor: Yes
• Crypto Engine: AES/DES
• Sram (kbytes): 8
• Eeprom (bytes): 2048
• Self Program Memory: YES
• External Bus Interface: 1
• Dram Memory: sdram
• Nand Interface: No
• Picopower: Yes
• Temp. Range (deg C): -40 to 85
• I/o Supply Class: 1.6 to 3.6
• Operating Voltage (vcc): 1.6 to 3.6
• Fpu: No
• Mpu / Mmu: no / no
• Timers: 8
• Output Compare Channels: 24
• Input Capture Channels: 24
• Pwm Channels: 24
• 32khz Rtc: Yes
• Calibrated Rc Oscillator: Yes

5.9
5.10
5.11
5.12
8077H–AVR–12/09
Error detection
Software Reset
Protection
Interrupts
The DMA controller can detect erroneous operation. Error conditions are detected individually
for each DMA channel, and the error conditions are:
Both the DMA controller and a DMA channel can be reset from the user software. When the
DMA controller is reset, all registers associated with the DMA controller is cleared. A software
reset can only be done when the DMA controller is disabled. When a DMA channel is reset, all
registers associated with the DMA channel are cleared. A software reset can only be done when
the DMA channel is disabled.
In order to insure safe operation some of the channel registers are protected during a transac-
tion. When the DMA channel Busy flag (CHnBUSY) is set for a channel, the user can only
modify these registers and bits:
The DMA Controller can generate interrupts when an error is detected on a DMA channel or
when a transaction is complete for a DMA channel. Each DMA channel has a separate interrupt
vector, and there are different interrupt flags for error and transaction complete.
If repeat is not enabled the transaction complete flag is set at the end of the Block Transfer. If
unlimited repeat is enabled, the transaction complete flag is also set at the end of each Block
Transfer.
• Write to memory mapped EEPROM memory locations.
• Reading EEPROM memory when the EEPROM is off (sleep entered).
• DMA controller or a busy channel is disabled in software during a transfer.
• CTRL register
• INTFLAGS register
• TEMP registers
• CHEN, CHRST, TRFREQ, REPEAT bits of the Channel CTRL register
• TRIGSRC register
XMEGA A
52