ATxmega128A1 Atmel Corporation, ATxmega128A1 Datasheet - Page 227

• Manufacturer Part Number: ATxmega128A1
• Manufacturer: Atmel Corporation

Specifications of ATxmega128A1

• Flash (kbytes): 128 Kbytes
• Pin Count: 100
• Max. Operating Frequency: 32 MHz
• Cpu: 8-bit AVR
• # Of Touch Channels: 16
• Hardware Qtouch Acquisition: No
• Max I/o Pins: 78
• Ext Interrupts: 78
• Usb Speed: No
• Usb Interface: No
• Spi: 12
• Twi (i2c): 4
• Uart: 8
• Graphic Lcd: No
• Video Decoder: No
• Camera Interface: No
• Adc Channels: 16
• Adc Resolution (bits): 12
• Adc Speed (ksps): 2000
• Analog Comparators: 4
• Resistive Touch Screen: No
• Dac Channels: 4
• Dac Resolution (bits): 12
• Temp. Sensor: Yes
• Crypto Engine: AES/DES
• Sram (kbytes): 8
• Eeprom (bytes): 2048
• Self Program Memory: YES
• External Bus Interface: 1
• Dram Memory: sdram
• Nand Interface: No
• Picopower: Yes
• Temp. Range (deg C): -40 to 85
• I/o Supply Class: 1.6 to 3.6
• Operating Voltage (vcc): 1.6 to 3.6
• Fpu: No
• Mpu / Mmu: no / no
• Timers: 8
• Output Compare Channels: 24
• Input Capture Channels: 24
• Pwm Channels: 24
• 32khz Rtc: Yes
• Calibrated Rc Oscillator: Yes

19.10.6
8077H–AVR–12/09
ADDRMASK - TWI Slave Address Mask Register
Accessing the DATA register will clear the slave interrupt flags and the CLKHOLD flag.
• Bit 7:1 - ADDRMASK[7:1]: Read/Write Direction
These bits in the ADDRMASK register can act as a second address match register, or an
address mask register depending on the ADDREN setting.
If ADDREN is set to zero, ADDRMASK can be loaded with a 7-bit Slave Address mask. Each bit
in ADDRMASK can mask (disable) the corresponding address bit in the ADDR register. If the
mask bit is one the address match between the incoming address bit and the corresponding bit
in ADDR is ignored, i.e. masked bits will always match.
If ADDREN is set to one, ADDRMASK can be loaded with a second slave address in addition to
the ADDR register. In this mode, the slave will match on 2 unique addresses, one in ADDR and
the other in ADDRMASK.
• Bit 0- ADDREN: Address Enable
By default this bit is zero and the ADDRMASK bits acts as an address mask to the ADDR regis-
ter. If this bit is set to one, the slave address match logic responds to the 2 unique addresses in
ADDR and ADDRMASK.
Bit
+0x05
Read/Write
Initial Value
R/W
7
0
R/W
6
0
R/W
5
0
ADDRMASK[7:1]
R/W
4
0
R/W
3
0
R/W
2
0
R/W
1
0
XMEGA A
ADDREN
R/W
0
0
ADDRMASK
227