DF61657CN35FTV Renesas Electronics America, DF61657CN35FTV Datasheet - Page 285

• Manufacturer Part Number: DF61657CN35FTV
• Description: IC H8SX/1657 MCU FLASH 120TQFP
• Manufacturer: Renesas Electronics America
• Series: H8® H8SX/1600r

Specifications of DF61657CN35FTV

• Core Processor: H8SX
• Core Size: 32-Bit
• Speed: 35MHz
• Connectivity: SCI, SmartCard
• Peripherals: DMA, PWM, WDT
• Number Of I /o: 82
• Program Memory Size: 768KB (768K x 8)
• Program Memory Type: FLASH
• Ram Size: 24K x 8
• Voltage - Supply (vcc/vdd): 3 V ~ 3.6 V
• Data Converters: A/D 8x10b; D/A 2x8b
• Oscillator Type: Internal
• Operating Temperature: -20°C ~ 75°C
• Package / Case: 120-TQFP, 120-VQFP
• For Use With: 3DK1657 - DEV EVAL KIT FOR H8SX/1657
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Eeprom Size: -

When the auto request setting is selected as the activation source, the cycle stealing or burst access
can be selected. When the total transfer size is not specified (DTCR = H'00000000), the transfer
counter is stopped and the transfer is continued without the limitation of the transfer count.
7.5
7.5.1
(1)
In dual address mode, the transfer source address is specified in DSAR and the transfer destination
address is specified in DDAR. A transfer at a time is performed in two bus cycles (when the data
bus width is less than the data access size or the access address is not aligned with the boundary of
the data access size, the number of bus cycles are needed more than two because one bus cycle is
divided into multiple bus cycles).
In the first bus cycle, data at the transfer source address is read and in the next cycle, the read data
is written to the transfer destination address.
The read and write cycles are not separated. Other bus cycles (bus cycle by other bus masters,
refresh cycle, and external bus release cycle) are not generated between read and write cycles.
The TEND signal output is enabled or disabled by the TENDE bit in DMDR. The TEND signal is
output in two bus cycles. When an idle cycle is inserted before the bus cycle, the TEND signal is
also output in the idle cycle. The DACK signal is not output.
Figure 7.2 shows an example of the signal timing in dual address mode and figure 7.3 shows the
operation in dual address mode.
Dual Address Mode
Operations
Address Modes
Figure 7.2 Example of Signal Timing in Dual Address Mode
Bφ
Address bus
RD
WR
TEND
DMA read
cycle
DSAR
DMA write
DDAR
cycle
Rev. 2.00 Jun. 28, 2007 Page 259 of 864
Section 7 DMA Controller (DMAC)
REJ09B0341-0200