DF2265TE13V Renesas Electronics America, DF2265TE13V Datasheet - Page 622

• Manufacturer Part Number: DF2265TE13V
• Description: IC H8S/2265 MCU FLASH 100TQFP
• Manufacturer: Renesas Electronics America
• Series: H8® H8S/2200r

Specifications of DF2265TE13V

• Core Processor: H8S/2000
• Core Size: 16-Bit
• Speed: 13MHz
• Connectivity: I²C, SCI, SmartCard
• Peripherals: LCD, POR, PWM, WDT
• Number Of I /o: 67
• Program Memory Size: 128KB (128K x 8)
• Program Memory Type: FLASH
• Ram Size: 4K x 8
• Voltage - Supply (vcc/vdd): 3 V ~ 5.5 V
• Data Converters: A/D 10x10b, D/A 2x8b
• Oscillator Type: Internal
• Operating Temperature: -20°C ~ 75°C
• Package / Case: 100-TQFP, 100-VQFP
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Eeprom Size: -

Section 22 Power-Down Modes
22.11.4 On-Chip Peripheral Module Interrupt
• Module stop mode
• Subactive mode / Watch mode
22.11.5 Writing to MSTPCR
MSTPCR should only be written to by the CPU.
22.11.6 Entering Subactive/Watch Mode and DTC Module Stop (Supported Only by
To enter subactive or watch mode, set DTC to module stop (write 1 to the MSTPA6 bit) and
reading the MSTPA6 bit as 1 before transiting mode. After transiting from subactive mode to
active mode, clear module stop.
When DTC activation factor occurs in subactive mode, DTC is activated when module stop is
cleared after active mode is entered.
Rev. 5.00 Sep. 01, 2009 Page 570 of 656
REJ09B0071-0500
Relevant interrupt operations cannot be performed in module stop mode. Consequently, if
module stop mode is entered when an interrupt has been requested, it will not be possible to
clear the CPU interrupt source or the DTC * activation source. Interrupts should therefore be
disabled before entering module stop mode.
Note: Supported only by the H8S/2268 Group.
On-chip peripheral modules (DTC * , TPU, IIC) that stop operation in subactive mode cannot
clear interrupts in subactive mode. Therefore, if subactive mode is entered when an interrupt is
requested, CPU interrupt factors cannot be cleared.
Interrupts should therefore before executing the SLEEP instruction and entering subactive or
watch mode.
Note: * Supported only by the H8S/2268 Group.
H8S/2268 Group)