AT91SAM9G45-CU-999 Atmel, AT91SAM9G45-CU-999 Datasheet - Page 172

• Manufacturer Part Number: AT91SAM9G45-CU-999
• Description: IC MCU ARM9 APMC 324TFBGA
• Manufacturer: Atmel
• Series: AT91SAMr

Specifications of AT91SAM9G45-CU-999

• Core Processor: ARM9
• Core Size: 16/32-Bit
• Speed: 400MHz
• Connectivity: EBI/EMI, Ethernet, I²C, IrDA, MMC, SPI, SSC, UART/USART, USB
• Peripherals: AC'97, DMA, I²S, LCD, POR, PWM, WDT
• Number Of I /o: 160
• Program Memory Size: 64KB (64K x 8)
• Program Memory Type: ROM
• Ram Size: 128K x 8
• Voltage - Supply (vcc/vdd): 0.9 V ~ 1.1 V
• Data Converters: A/D 8x10b
• Oscillator Type: Internal
• Operating Temperature: -40°C ~ 85°C
• Package / Case: 324-TFBGA
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Eeprom Size: -
• Lead Free Status / Rohs Status: Supplier Unconfirmed

20.2.7.7
Figure 20-8. NAND Flash Application Example
172
External Bus Interface
NAND Flash Signals
AT91SAM9G45
NAND Flash Support
External Bus Interfaces integrate circuitry that interfaces to NAND Flash devices.
The NAND Flash logic is driven by the Static Memory Controller on the NCS3 address space.
Programming the EBI_CS3A field in the EBI_CSA Register in the Chip Configuration User Inter-
face to the appropriate value enables the NAND Flash logic. For details on this register, refer to
the Bus Matrix Section. Access to an external NAND Flash device is then made by accessing
the address space reserved to NCS3 (i.e., between 0x4000 0000 and 0x4FFF FFFF).
The NAND Flash Logic drives the read and write command signals of the SMC on the NANDOE
and NANDWE signals when the NCS3 signal is active. NANDOE and NANDWE are invalidated
as soon as the transfer address fails to lie in the NCS3 address space. See
172
section.
The address latch enable and command latch enable signals on the NAND Flash device are
driven by address bits A22 and A21 of the EBI address bus. The command, address or data
words on the data bus of the NAND Flash device are distinguished by using their address within
the NCSx address space. The chip enable (CE) signal of the device and the ready/busy (R/B)
signals are connected to PIO lines. The CE signal then remains asserted even when NCSx is
not selected, preventing the device from returning to standby mode.
EBI
for more information. For details on these waveforms, refer to the Static Memory Controller
PIO
PIO
NCSx/NANDCS
D[7:0]
A[22:21]
NANDWE
NANDOE
Not Connected
CE
R/B
ALE
CLE
NOE
NWE
AD[7:0]
NAND Flash
Figure 20-8 on page
6438F–ATARM–21-Jun-10