H8S2110B RENESAS [Renesas Technology Corp], H8S2110B Datasheet - Page 428

• Manufacturer Part Number: H8S2110B
• Description: Renesas 16-Bit Single-Chip Microcomputer Renesas H8S Family/H8S/2100 Series
• Manufacturer: RENESAS [Renesas Technology Corp]

Section 15 Host Interface LPC Interface (LPC)
15.4
15.4.1
The host interface is activated by setting one of bits LPC3E to LPC1E in HICR0 to 1 in single-
chip mode. When the host interface is activated, the related I/O ports (ports 37 to 30, ports 83 and
82) function as dedicated host interface input/output pins. In addition, setting the FGA20E, PMEE,
LSMIE, and LSCIE bits to 1 adds the related I/O ports (ports 81 and 80, ports PB0 and PB1) to the
host interface’s input/output pins.
Use the following procedure to activate the host interface after a reset release.
1. Read the signal line status and confirm that the LPC module can be connected. Also check that
2. When using channel 3, set LADR3 to determine the channel 3 I/O address and whether
3. Set the enable bit (LPC3E to LPC1E) for the channel to be used.
4. Set the enable bits (GA20E, PMEE, LSMIE, and LSCIE) for the additional functions to be
5. Set the selection bits for other functions (SDWNE, IEDIR).
6. As a precaution, clear the interrupt flags (LRST, SDWN, ABRT, OBF). Read IDR or TWR15
7. Set interrupt enable bits (IBFIE3 to IBFIE1, ERRIE) as necessary.
Rev. 2.00 Mar 21, 2006 page 390 of 518
REJ09B0299-0200
the LPC module is initialized internally.
bidirectional data registers are to be used.
used.
to clear IBF.
Operation
Host Interface Activation