ISP1362EE/01 PHILIPS [NXP Semiconductors], ISP1362EE/01 Datasheet - Page 121

• Manufacturer Part Number: ISP1362EE/01
• Description: Single-chip Universal Serial Bus On-The-Go controller
• Manufacturer: PHILIPS [NXP Semiconductors]

Philips Semiconductors
Table 124: DcEndpointStatus register: bit allocation
9397 750 12337
Product data
Bit
Symbol
Reset
Access
EPSTAL
R
7
0
16.2.3 Stall Endpoint or Unstall Endpoint (40H–4FH/80H–8FH)
EPFULL1
Table 125: DcEndpointStatus register: bit description
These commands are used to stall or unstall an endpoint. The commands modify the
content of the DcEndpointStatus register (see
A stalled control endpoint is automatically unstalled when it receives a SET-UP token,
regardless of the packet content. If the endpoint should stay in its stalled state, the
microprocessor can re-stall it with the Stall Endpoint command.
When a stalled endpoint is unstalled (either by using the Unstall Endpoint command
or by receiving a SET-UP token), it is also re-initialized. This flushes the buffer: if it is
an OUT buffer, it waits for a DATA 0 PID; if it is an IN buffer, it writes a DATA 0 PID.
Code (Hex): 40 to 4F — stall (control OUT, control IN, endpoint 1 to 14)
Code (Hex): 80 to 8F — unstall (control OUT, control IN, endpoint 1 to 14)
Transaction — none (code only)
Bit
7
6
5
4
3
2
1
0
R
6
0
Symbol
EPSTAL
EPFULL1
EPFULL0
DATA_PID
OVERWRITE
SETUPT
CPUBUF
-
EPFULL0
R
5
0
Rev. 03 — 06 January 2004
DATA_PID
Description
This bit indicates whether the endpoint is stalled or not
(1 = stalled; 0 = not stalled).
Set to logic 1 by a Stall Endpoint command, cleared to logic 0 by
an Unstall Endpoint command. The endpoint is automatically
unstalled on receiving a SET-UP token.
Logic 1 indicates that the secondary endpoint buffer is full.
Logic 1 indicates that the primary endpoint buffer is full.
This bit indicates the data PID of the next packet (0 = DATA PID;
1 = DATA1 PID).
This bit is set by hardware. Logic 1 indicates that a new Set-up
packet has overwritten the previous set-up information, before it
was acknowledged or before the endpoint was stalled. This bit is
cleared by reading, if writing the set-up data has finished.
Firmware must check this bit before sending an Acknowledge
Set-up command or stalling the endpoint. Upon reading logic 1,
the firmware must stop ongoing set-up actions and wait for a
new Set-up packet.
Logic 1 indicates that the buffer contains a Set-up packet.
This bit indicates which buffer is currently selected for CPU
access (0 = primary buffer; 1 = secondary buffer).
reserved
R
4
0
WRITE
OVER
R
3
0
Table
SETUPT
Single-chip USB OTG controller
124).
R
2
0
© Koninklijke Philips Electronics N.V. 2004. All rights reserved.
CPUBUF
R
1
0
ISP1362
reserved
121 of 150
0
-
-