SAM9263 Atmel Corporation, SAM9263 Datasheet - Page 95

• Manufacturer Part Number: SAM9263
• Manufacturer: Atmel Corporation

Specifications of SAM9263

• Flash (kbytes): 0 Kbytes
• Pin Count: 324
• Max. Operating Frequency: 240 MHz
• Cpu: ARM926
• Hardware Qtouch Acquisition: No
• Max I/o Pins: 160
• Ext Interrupts: 160
• Usb Transceiver: 3
• Usb Speed: Full Speed
• Usb Interface: Host, Device
• Spi: 2
• Twi (i2c): 1
• Uart: 4
• Can: 1
• Ssc: 2
• Ethernet: 1
• Sd / Emmc: 2
• Graphic Lcd: Yes
• Video Decoder: No
• Camera Interface: Yes
• Resistive Touch Screen: No
• Temp. Sensor: No
• Crypto Engine: No
• Sram (kbytes): 96
• Self Program Memory: NO
• External Bus Interface: 2
• Dram Memory: sdram
• Nand Interface: Yes
• Picopower: No
• Temp. Range (deg C): -40 to 85
• I/o Supply Class: 1.8/3.3
• Fpu: No
• Mpu / Mmu: No / Yes
• Timers: 3
• Output Compare Channels: 3
• Input Capture Channels: 3
• Pwm Channels: 4
• 32khz Rtc: Yes
• Calibrated Rc Oscillator: No

13. AT91SAM9263 Boot Program
13.1
13.2
6249I–ATARM–3-Oct-11
Overview
Flow Diagram
The Boot Program integrates different programs permitting download and/or upload into the dif-
ferent memories of the product.
First, it initializes the Debug Unit serial port (DBGU) and the USB Device Port.
Then the SD Card Boot program is executed. It looks for a boot.bin file in the root directory of a
FAT12/16/32 formatted SD Card. If such a file is found, code is downloaded into the internal
SRAM. This is followed by a remap and a jump to the first address of the SRAM.
If the SD Card is not formatted or if boot.bin file is not found, NAND Flash Boot program is then
executed.
The NAND Flash Boot program looks for a sequence of seven valid ARM exception vectors. If
such a sequence is found, code is downloaded into the internal SRAM. This is followed by a
remap and a jump to the first address of the SRAM.
If no valid ARM vector sequence is found, the DataFlash
a sequence of seven valid ARM exception vectors in a DataFlash connected to the SPI. All
these vectors must be B-branch or LDR load register instructions except for the sixth vector.
This vector is used to store the size of the image to download.
If a valid sequence is found, code is downloaded into the internal SRAM. This is followed by a
remap and a jump to the first address of the SRAM.
If no boot.bin file is found, SAM-BA
USB device, or on the DBGU serial port.
The Boot Program implements the algorithm in
®
Boot is then executed. It waits for transactions either on the
Figure
13-1.
®
Boot program is executed. It looks for
AT91SAM9263
95