SAM9263 Atmel Corporation, SAM9263 Datasheet - Page 269

• Manufacturer Part Number: SAM9263
• Manufacturer: Atmel Corporation

Specifications of SAM9263

• Flash (kbytes): 0 Kbytes
• Pin Count: 324
• Max. Operating Frequency: 240 MHz
• Cpu: ARM926
• Hardware Qtouch Acquisition: No
• Max I/o Pins: 160
• Ext Interrupts: 160
• Usb Transceiver: 3
• Usb Speed: Full Speed
• Usb Interface: Host, Device
• Spi: 2
• Twi (i2c): 1
• Uart: 4
• Can: 1
• Ssc: 2
• Ethernet: 1
• Sd / Emmc: 2
• Graphic Lcd: Yes
• Video Decoder: No
• Camera Interface: Yes
• Resistive Touch Screen: No
• Temp. Sensor: No
• Crypto Engine: No
• Sram (kbytes): 96
• Self Program Memory: NO
• External Bus Interface: 2
• Dram Memory: sdram
• Nand Interface: Yes
• Picopower: No
• Temp. Range (deg C): -40 to 85
• I/o Supply Class: 1.8/3.3
• Fpu: No
• Mpu / Mmu: No / Yes
• Timers: 3
• Output Compare Channels: 3
• Input Capture Channels: 3
• Pwm Channels: 4
• 32khz Rtc: Yes
• Calibrated Rc Oscillator: No

25. DMA Controller (DMAC)
25.1
25.2
25.3
25.3.1
6249I–ATARM–3-Oct-11
Overview
Block Diagram
Functional Description
Basic Definitions
The DMA Controller (DMAC) is an AHB-central DMA controller core that transfers data from a
source peripheral to a destination peripheral over one or more AMBA buses. One channel is
required for each source/destination pair. In the most basic configuration, the DMAC has one
master interface and one channel. The master interface reads the data from a source and writes
it to a destination. Two AMBA transfers are required for each DMA data transfer. This is also
known as a dual-access transfer.
The DMAC is programmed via the AHB slave interface.
Figure 25-1. DMA Controller (DMAC) Block Diagram
Source peripheral: Device on an AMBA layer from where the DMAC reads data, which is then
stored in the channel FIFO. The source peripheral teams up with a destination peripheral to form
a channel.
Destination peripheral: Device to which the DMAC writes the stored data from the FIFO (previ-
ously read from the source peripheral).
Memory: Source or destination that is always “ready” for a DMA transfer and does not require a
handshaking interface to interact with the DMAC. A peripheral should be assigned as memory
DMARQ0..3
AHB Master
AHB Slave
AHB Master
Handshaking
AHB Slave
Interface
Interface
Hardware
Interface
DMA Controller
SRC
FSM
Channel 0
CFG
FIFO
Channel 1
FSM
DST
AT91SAM9263
Generator
Interrupt
irq_dma
269