SAM9263 Atmel Corporation, SAM9263 Datasheet - Page 304

• Manufacturer Part Number: SAM9263
• Manufacturer: Atmel Corporation

Specifications of SAM9263

• Flash (kbytes): 0 Kbytes
• Pin Count: 324
• Max. Operating Frequency: 240 MHz
• Cpu: ARM926
• Hardware Qtouch Acquisition: No
• Max I/o Pins: 160
• Ext Interrupts: 160
• Usb Transceiver: 3
• Usb Speed: Full Speed
• Usb Interface: Host, Device
• Spi: 2
• Twi (i2c): 1
• Uart: 4
• Can: 1
• Ssc: 2
• Ethernet: 1
• Sd / Emmc: 2
• Graphic Lcd: Yes
• Video Decoder: No
• Camera Interface: Yes
• Resistive Touch Screen: No
• Temp. Sensor: No
• Crypto Engine: No
• Sram (kbytes): 96
• Self Program Memory: NO
• External Bus Interface: 2
• Dram Memory: sdram
• Nand Interface: Yes
• Picopower: No
• Temp. Range (deg C): -40 to 85
• I/o Supply Class: 1.8/3.3
• Fpu: No
• Mpu / Mmu: No / Yes
• Timers: 3
• Output Compare Channels: 3
• Input Capture Channels: 3
• Pwm Channels: 4
• 32khz Rtc: Yes
• Calibrated Rc Oscillator: No

25.4.3
Name: DMAC_LLPx
Addresses:0x00800010 [0], 0x00800068 [1]
Access: Read-write
Reset: 0x0
The address offset for each channel is: 0x10+[x * 0x58]
For example, LLP0: 0x010, LLP1: 0x068, etc.
• LOC: Address of the next LLI
Starting address in memory of next LLI if block chaining is enabled. Note that the two LSBs of the starting address are not
stored because the address is assumed to be aligned to a 32-bit boundary.
The user need to program this register to point to the first Linked List Item (LLI) in memory prior to enabling the channel if
block chaining is enabled.
The LLP register has two functions:
If LLP.LOC is set to 0x0, then transfers using linked lists are NOT enabled. This register must be programmed prior to
enabling the channel in order to set up the transfer type.
It (LLP.LOC != 0) contains the pointer to the next Linked Listed Item for block chaining using linked lists.
304
31
23
15
7
AT91SAM9263
Linked List Pointer Register for Channel x
30
22
14
6
1. The logical result of the equation LLP.LOC != 0 is used to set up the type of DMA trans-
2. The DMAC_LLPx register is also used to point to the address where write back of the
fer (single or multi-block).
control and source/destination status information occurs after block completion.
29
21
13
5
LOC
28
20
12
4
LOC
LOC
LOC
27
19
11
3
26
18
10
2
25
17
9
1
0
6249I–ATARM–3-Oct-11
24
16
8
0
0