SAM9263 Atmel Corporation, SAM9263 Datasheet - Page 901

• Manufacturer Part Number: SAM9263
• Manufacturer: Atmel Corporation

Specifications of SAM9263

• Flash (kbytes): 0 Kbytes
• Pin Count: 324
• Max. Operating Frequency: 240 MHz
• Cpu: ARM926
• Hardware Qtouch Acquisition: No
• Max I/o Pins: 160
• Ext Interrupts: 160
• Usb Transceiver: 3
• Usb Speed: Full Speed
• Usb Interface: Host, Device
• Spi: 2
• Twi (i2c): 1
• Uart: 4
• Can: 1
• Ssc: 2
• Ethernet: 1
• Sd / Emmc: 2
• Graphic Lcd: Yes
• Video Decoder: No
• Camera Interface: Yes
• Resistive Touch Screen: No
• Temp. Sensor: No
• Crypto Engine: No
• Sram (kbytes): 96
• Self Program Memory: NO
• External Bus Interface: 2
• Dram Memory: sdram
• Nand Interface: Yes
• Picopower: No
• Temp. Range (deg C): -40 to 85
• I/o Supply Class: 1.8/3.3
• Fpu: No
• Mpu / Mmu: No / Yes
• Timers: 3
• Output Compare Channels: 3
• Input Capture Channels: 3
• Pwm Channels: 4
• 32khz Rtc: Yes
• Calibrated Rc Oscillator: No

44.5.2
44.5.2.1
44.5.2.2
6249I–ATARM–3-Oct-11
LCD Controller Core
Configuration Block
Datapath
The configuration block is a set of programmable registers that are used to configure the LCDC
core operation. These registers are written via the AHB slave interface. Only word access is
allowed.
The description of the configuration registers can be found in
Interface” on page
The datapath block contains five submodules: FIFO, Serializer, Palette, Dithering and Shifter.
The structure of the datapath is shown in
Figure 44-2. Datapath Structure
This module transforms the data read from the memory into a format according to the LCD mod-
ule used. It has four different interfaces: the input interface, the output interface, the
configuration interface and the control interface.
• The input interface connects the datapath with the DMA controller. It is a dual FIFO interface
with a data bus and two push lines that are used by the DMA controller to fill the FIFOs.
925.
Serializer
Dithering
Palette
Output
Shifter
FIFO
Figure
Input Interface
Output Interface
44-2.
Configuration IF
Control Interface
“LCD Controller (LCDC) User
AT91SAM9263
901