N25Q128A11B1240E NUMONYX, N25Q128A11B1240E Datasheet - Page 47

• Manufacturer Part Number: N25Q128A11B1240E
• Manufacturer: NUMONYX

Specifications of N25Q128A11B1240E

• Cell Type: NOR
• Density: 128Mb
• Access Time (max): 7ns
• Interface Type: Serial (SPI)
• Boot Type: Bottom
• Address Bus: 1b
• Operating Supply Voltage (typ): 1.8V
• Operating Temp Range: -40C to 85C
• Package Type: TBGA
• Program/erase Volt (typ): 1.7 to 2/8.5 to 9.5V
• Sync/async: Synchronous
• Operating Temperature Classification: Industrial
• Operating Supply Voltage (min): 1.7V
• Operating Supply Voltage (max): 2V
• Word Size: 8b
• Number Of Words: 16M
• Supply Current: 20mA
• Mounting: Surface Mount
• Pin Count: 24
• Lead Free Status / Rohs Status: Supplier Unconfirmed

6.5.7
The bit is set (FSR<2>=1) within the Erase Suspend Latency time, that is as soon as the
Program/Erase Suspend command (PES) has been issued, therefore the device may still
complete the operation before entering the Suspend Mode.
The Program Suspend Status should be considered valid when the P/E Controller bit is high
(FSR<7>=1).
When a Program/Erase Resume command (PER) is issued the Program Suspend Status bit
returns Low (FSR<2>=0)
Protection Status bit
The bit 1 of the Flag Status Register represents the Protection Status bit. It indicates that an
Erase or Program operation has tried to modify the contents of a protected array sector, or
that a modify operation has tried to access to a locked OTP space. The Protection Status bit
is related to all possible protection violations as follows:
Once set High, the Protection Status bit can only be reset Low (FSR<1>=0) by a Clear Flag
Status Register command (CLFSR). If set High it should be reset before a new command is
issued, otherwise the new command will appear to fail.
The sector is protected by Software Protection Mode 1 (SPM1) Lock registers,
The sector is protected by Software Protection Mode 2 (SPM2) Block Protect Bits
(standard SPI Status Register),
An attempt to program OTP when locked,
A Write Status Register command (WRSR) on STD SPI Status Register when locked by
the SRWD bit in conjunction with the Write Protect (W/VPP) signal (Hardware Protection
Mode).
47/185