N25Q128A11B1240E NUMONYX, N25Q128A11B1240E Datasheet - Page 22

• Manufacturer Part Number: N25Q128A11B1240E
• Manufacturer: NUMONYX

Specifications of N25Q128A11B1240E

• Cell Type: NOR
• Density: 128Mb
• Access Time (max): 7ns
• Interface Type: Serial (SPI)
• Boot Type: Bottom
• Address Bus: 1b
• Operating Supply Voltage (typ): 1.8V
• Operating Temp Range: -40C to 85C
• Package Type: TBGA
• Program/erase Volt (typ): 1.7 to 2/8.5 to 9.5V
• Sync/async: Synchronous
• Operating Temperature Classification: Industrial
• Operating Supply Voltage (min): 1.7V
• Operating Supply Voltage (max): 2V
• Word Size: 8b
• Number Of Words: 16M
• Supply Current: 20mA
• Mounting: Surface Mount
• Pin Count: 24
• Lead Free Status / Rohs Status: Supplier Unconfirmed

4.3
Note:
Note:
22/185
Quad SPI (QIO-SPI) protocol
Quad SPI (QIO-SPI) protocol: instructions, addresses, and I/O data are always transmitted
on four data lines DQ0, DQ1, W/VPP(DQ2), and HOLD / (DQ3).
The exception is the Program/Erase cycle performed with the VPP, in which case the device
temporarily goes to Extended SPI protocol. Going temporarily into Extended SPI protocol
allows the application either to:
As soon as the VPP pin voltage goes low, the protocol returns to the QIO-SPI protocol.
In QIO-SPI protocol the W and HOLD/ (RESET) functionality is disabled when the device is
selected (S signal low).
When used in the QIO-SPI mode, these devices can be driven by a micro controller in either
of the two following modes:
Please refer to the SPI modes for a detailed description of the 2 modes.
In the Extended SPI protocol only Address and data are allowed to be transmitted on 4 data
lines, However in QIO-SPI protocol, the address, data and instructions are transmitted
across 4 data lines.
This working mode is set in either bit 7 of the Volatile Enhanced Configuration Register
(VECR) or in bit 3 of the Non Volatile Configuration Register (NVCR).
This mode can be set using two ways
check the polling bits: WIP bit in the Status Register or Program/Erase Controller bit in
the Flag Status Register
perform Program/Erase suspend functions.
CPOL=0, CPHA=0
CPOL=1, CPHA=1
Volatile: by setting bit 7 of the VECR to 0, the device enters QIO-SPI protocol
immediately after the Write Enhanced Volatile Configuration Register sequence
completes. The device returns to the default working protocol (defined by the NVCR)
on the next power on.
Default/ Non- Volatile: This is default protocol on power up. By setting bit 3 of the
NVCR to 0, the device enters QIO-SPI protocol on the subsequent power-on. After all
subsequent power-on sequences, the device still starts in QIO-SPI protocol unless bit 3
of the NVCR is set to 1 (default value, corresponding to Extended SPI mode).